Service And Adjustments - McCulloch 532 43 67-90 Operator's Manual

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS:
1. Depress clutch/brake pedal fully and set parking brake.
2. Place motion control lever in neutral (N) position.
3. Place deck clutch in "DISENGAGED" position.
4. Turn ignition key to "STOP" and remove key.
5. Make sure the blade and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
RIDING MOWER
TO REMOVE MOWER
1. Place deck clutch in "DISENGAGED" position.
2. Move mower height adjustment lift lever forward to low er
mower to its lowest po si tion.
3. Remove mandrel cover.
4. Remove pins holding left and right front mower
suspension arms in place.
5. Remove bolt holding deck front to rear leveling rod in
place.
6. Remove pin holding deck lift link arm in place.
7. Remove bolt holding deck side to side leveling rod in
place.
8. Remove belt from around pulleys.
9. Slide deck out from under side of mower.
Front Leveling Rod
Bolt
Mower
Suspension Arm
Pin
Deck Leveling Side to
Side Rod Bolt
Mandrel Cover
TO INSTALL MOWER
Install in reverse order following instructions in "TO RE-
MOVE MOWER" section.
17
Deck Lift Link
Pin