Installing The Power Interposer Board; System Top Cover - Dell PowerEdge T630 Owner's Manual

Next steps
1. Install the power interposer board.
2. Install the system board. For more information, see
3. Connect the power cables to the system board and the hard-drive backplane.
4. If applicable, install the cooling fan assembly.
5. Install the cooling shroud.
6. Install the PCIe card holders.
7. Install the power supply module(s) in their original locations.
8. Follow the procedure listed in

Installing the power interposer board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Ensure that you read the
Steps
1. Install the power distribution board (PDB).
2. Align the power interposer board (PIB) connector with the connector on the PDB.
3. Keeping the grooves on the PIB aligned with the pins on the chassis, connect the PIB to the
connector on the PDB.
Next steps
1. Install the system board. For more information, see
2. Connect the power cables to the system board and the hard-drive backplane.
3. If applicable, install the cooling fan assembly.
4. Install the cooling shroud.
5. Install the PCIe card holders.
6. Install the power supply module(s) in their original locations.
7. Follow the procedure listed in

System top cover

Do not remove the system top cover unless you are converting the system from tower to rack mode.
144
After working inside your
Safety instructions.
After working inside your
Installing the system board.
system.
Installing the system board.
system.