REVERSE HARDWARE ON CABINET
a. Remove the base grille. Grasp it at the bottom and
pull it straight out.
b. Using a Torxdriver, remove the hinge (and shim
glued to it) and plastic washer from the bottom right
side of the cabinet.
c. Reinstall the hinge (and shim glued to it) and
plastic washer to the bottom left side of the cabinet.
DO NOT REMOVE
a. Remove the hinge bracket (and shim glued to it)
from the center right side of the cabinet by removing
the three outermost Torx screws.
b. Remove the three outermost Torx screws from the
center left side of the cabinet and screw them into
the holes at the right side uncovered in Step (a) above.
Place the center hinge bracket over the holes at the
center left side of the cabinet, insert the screws you
removed from the opposite side, and tighten them.
TRANSFER TOP HINGE TO THE LEFT.
Interchange hinge and screws at top right with
screws at top left of cabinet. Do not tighten screws
on hinge side at this time.
TRANSFER DOOR STOPS.
a. On each door, move
the metal door stop from
the right end to th; left end. <
b. Move any screws from the left end to the right end.