Maytag NEPTUNE MAH-2 Use & Care Manual page 24

Q & A
UESTIONS
Q. What's the best cycle to use if I have stains on my laundry?
A. Select Cotton/Sturdy fabrics, the Heavy soil wash time and the Stain Cycle option. Pretreat the stains with a laundry pre-
treat product. Refer to the "Stain Brain" under Help for more information on treating specific stains.
Q. How large of a load can I wash in my Maytag Neptune
A. The tub can be loaded completely full with dry, unfolded clothes. However, do not pack the tub tightly. If the load is heavily
soiled it is very important not to overload the washer.
Q. At the end of the cycle my load comes out wetter than normal.What causes this?
A. During tumble and spin the washer may have had difficulty getting to a full spin speed because the load was not evenly dis-
tributed.This can occur with small loads, heavy items or a load in which too much detergent was used, causing over-sudsing.
Redistribute the load in the washer, close the door and follow these steps. Touch "More Cycles", "Spin", and Start/
Pause.
Q. My laundry items seem to be very wrinkled at the end of the cycle. What can I do to correct the problem?
A. Wrinkling is caused by the combination of heat and pressure. Be sure wrinkle free or permanent press fabrics are washed
on the Wrinkle Free cycle, Wrinkle Free Spin, and a cold rinse is used. (See pg. 5 for Wash/Rinse Temperature).
DO NOT USE MAX-EXTRACT.
Q. My whites are not as white as I'd like.What can I do?
A. Wash white loads using the Cotton/Sturdy fabric selection. Select the hot wash/cold rinse temperature setting and put 3/4
cup of chlorine bleach in the bleach dispenser. The bleach will be dispensed in the final minutes of the wash providing for
optimal whitening. Maytag recommends a hot water wash temperature of 120-140˚ F (49˚- 60˚ C).
NSWERS
® washer?
23