Sony DAV-DZ850KW Operating Instructions Manual page 94

0.00 - 7.00 m
0 - 23 ft
Be sure to change the value in the Setup Display
when you move the speakers.
[L/R]
1)3)
3.00 m/10 ft
(appears when you
set [SURROUND] to
[YES] in the
[CONNECTION]
setting.)
1)
When you perform the Quick Setup (page 23), the
default settings are changed.
2)
0.00 to 7.01 meters for North American models.
3)
3.04 m/10 ft for North American models.
Note
• Depending on the input stream, the [DISTANCE]
setting may not be effective.
• When the speaker distance setting is not in the
recommended range,
being the number).
recommended distance.
x [LEVEL (FRONT)]
You can vary the level of front speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
[L/R]
0.0 dB
[CENTER]
0.0 dB
(appears when you
set [CENTER] to
[YES] in the
[CONNECTION]
setting.)
94
GB
2)
/
Surround speaker distance
from the listening position can
be set from 0.00 to 7.00
2)
meters (0 to 23 ft).
/ ** m is displayed (**
indicates over the
indicates below.
Set this between –6.0 dB and
+6.0 dB.
Set this between –6.0 dB and
+6.0 dB.
[SUBWOOFER] Set this between –6.0 dB and
0.0 dB
+6.0 dB.
x [LEVEL (SURROUND)]
You can vary the level of surround speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
[L/R] Set this between –6.0 dB and
0.0 dB
+6.0 dB.
(appears when you
set [SURROUND]
to [YES] in the
[CONNECTION]
setting.)
To adjust the volume of all the
speakers at one time
Turn the VOLUME control on the unit, or press
VOLUME +/– on the remote.
x [TEST TONE]
The speakers will emit a test tone to adjust
[LEVEL (FRONT)] and [LEVEL
(SURROUND)].
[OFF] The test tone is not emitted from the
speakers.
[ON] The test tone is emitted from each speaker
in sequence while adjusting level. When
you select one of the [SPEAKER SETUP]
items, the test tone is emitted from each
speaker in sequence.
Adjusting the speaker level by
using the test tone
1
Press DISPLAY when the system is
in stop mode.
The Control Menu display appears.
2
Press X/x to select
then press .
The options for [SETUP] appear.
3
Press X/x to select [CUSTOM], then
press .
The Setup Display appears.
4
Press X/x repeatedly to select
[SPEAKER SETUP], then press
c.
[SETUP],
or