Table of Contents
Advertisement
Turn the head until the 'D' matches the one on the
burner base. Turn the head over and place it on
the burner base.
To fi t the small inner burner, fi nd the larger
electrode notch in the burner rim. Line this up
with the white ignition electrode and place the
inner burner on the large base ring.
A electrode notch
Now fi t the two trim rings, making sure that they
are sitting down properly.
Griddle
Always clean the griddle after use. Allow to cool
completely before removing. Immerse the griddle
plate in hot soapy water. Use a soft cloth or, for
stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE
CLEANERS AS THESE WILL DAMAGE THE
SURFACE.
Grill
The grill pan and grid should be washed in hot
soapy water. After grilling meats or any foods that
soil, leave to soak for a few minutes in the sink
immediately after use. Stubborn particles may be
removed from the grid by using a nylon brush.
Control Panel and Doors
Avoid using any abrasive cleaners including
cream cleaners, e.g. Cif, on brushed Stainless
Steel surfaces. For best results use a liquid
detergent e.g. Domestos Multi Surface Cleaner.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water. Wipe with a clean dampened
cloth then polish with a dry cloth. The oven doors
should only be cleaned with a soft cloth wrung
out in clean hot soapy water.
B
ignition electrode
Ovens
The ovens have removable panels that have
been coated with a special enamel that partly
cleans itself. This does not stop all marks on the
lining, but helps to reduce the amount of manual
cleaning needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below
this temperature, occasionally remove the
panels and wipe with a lint free cloth and hot
soapy water. The panels should then be dried
and replaced and the oven heated at 200°C
for about one hour. This will ensure the Cook
& Clean panels are working effectively.
Don't use steel wool (Brillo) or any other materials
which will scratch the surface. Don't use oven
cleaning pads.
Removing the Oven Linings
Some of the lining panels can be removed for
cleaning and for cleaning behind. Remove the
shelves fi rst.
The side panels of either oven can be removed.
Each side of the oven is fi xed with four fi xing
screws. You don't have to remove the screws
to remove the oven linings. Lift each side panel
upwards and they will slide off the screws. Then
pull them forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
18
Advertisement
Table of Contents
