OPERATING ELEMENTS button for opening the control unit Button for switching the device on and off and for muting the device Volume control Softkeys. The function of the Softkeys depends on the contents of the dis- play at the time OK button for confirming menu entries and for leaving the menu DEQ button for calling up the equaliz-...
CONTENTS Notes ..........6 CD operation ......... 18 Road safety ..........6 Starting CD operation and inserting Fitting ............6 the CD ........... 18 Accessories ..........6 Removing the CD ........18 Guarantee ..........6 Selecting a track ........18 International telephone information ..
Note A 09. Before you use your car radio for the first time, If an adapter cable is used (Blaupunkt No. please read this guide carefully and make 7 607 889 093) the CDC A 05 or CDC A 071 yourself familiar with the device.
Remove the incorrect card, and insert a Key- If one KeyCard is lost or damaged you can obtain a replacement through your Blaupunkt Card that is known to the device. dealer. Removing the KeyCard If you use two KeyCards, the settings of the...
THEFT PROTECTION Training a new KeyCard / To “train” a new KeyCard in case of loss or damage: Entering the master code Insert the first KeyCard and switch the If you no longer have a valid KeyCard for your device on. device, and would like to train a new KeyCard: Press the MENU button, 8.
THEFT PROTECTION SWITCHING ON AND OFF Display Radio Passport Data Switching on and off Using the KeyCard supplied, you can view There are a number of methods for switching Radio Passport data such as device name, the device on or off. type number (7 6 ...) and device number in the display.
VOLUME Muting Adjusting the volume You can reduce the level of the volume (mute) The volume can be adjusted in steps from 0 suddenly. (off) to 66 (maximum). Press the main button, 2. To increase the volume, turn the volume “MUTE”...
TONE AND VOLUME Adjusting the left/right volume Tone and volume balance Note: In order to adjust the balance, press the You can make separate adjustments to the AUD button, 9. bass, treble and loudness for each audio “BASS” appears in the display. source.
DISPLAY Night-time display brightness Adjusting the display Press the MENU button, 8. You can adjust the display to its location in button, 7, as often your vehicle and to your taste. Press the as is necessary for “DIM NGHT” to ap- Adjusting the viewing angle pear in the display.
RADIO OPERATION Radio Operation Switching TA on and off To use the TA function: Switching to Radio Mode Press the softkey, 4, indicating “TA”. If the car radio is in another operating mode: The TA function is active when “TA” appears Press the TUNE button, >.
RADIO OPERATION Setting the station Saving a station There are a number of ways to set the sta- Saving a station manually tion. Choose the desired memory level: FM I, Automatic station search FM II, FMT, M or MT. button, 7. Press the Tune in the desired station as described The next station that can be received is tuned...
RADIO OPERATION Scanning through stations Stop the SCAN, continue listening to a station Scanning through available stations Press any button on the arrow block, (Radio SCAN) You can listen to short samples of all current- The scanning process is stopped, and the last ly receivable stations.
RADIO OPERATION As soon as a station of the selected type is found, the device switches from the present Select a saved program type by press- station, or out of CD, cassette tape, MiniDisc ing one of the softkeys, 4, indicating or CD changer mode (depending on how your “ST1”...
RADIO OPERATION Press the OK button, 5 or the MENU Changing information displayed button, 8, to leave the menu. The set- You can select which information is shown tings are then saved. on the display. The upper display line (the headline) can display the station name, fre- Bandwidth selection in the presence of quency or program type.
So-called CD-Rs (“home-made” CDs) can also usually be played. However, because of Note: the varying CD quality, Blaupunkt cannot If you do not remove the CD within 30 sec- guarantee correct function. onds it will be drawn back into the drive.
CD OPERATION For information on setting the sampling dura- program the tracks in any order, but they will tion, read the paragraphs on “Adjusting the be played in ascending order. If favourite track Sample Duration” in the “Radio Operation” play is active, only the tracks previously pro- section.
CD OPERATION buttons, 7, to select Delete the list of favourite tracks for a Use the your character. If a location is to remain empty, select the underscore. You can delete the whole list of favourite tracks button, 7, to change for a CD.
On page 6 of this guide you can find which Display of CD number, track number CD changers can be used with this device. and time. You can also refer to your Blaupunkt dealer. Display of CD number, track number and playing time. Note: The operating instructions for your CD chang- Display of CD name and track number.
CD CHANGER OPERATION In order to play the tracks on all the inserted If you attempt to assign more than 99 names, CDs in a random sequence the display will show “FULL”. press the softkey, 4, indicating “MIX” Entering and changing CD names again.
CD CHANGER OPERATION Deleting all CD names Switching favourite track play on and off In order to begin playing the programmed Listen to a CD in CD changer mode. favourite tracks on the inserted CD, or to stop Press the MENU button, 8. playing only the favourite tracks buttons, 7, to select Use the...
TIME CLOCK - Time Adjust the minutes with the but- ton, 7. Setting the time Press the OK button, 5 or the MENU button, 8, to leave the menu. The set- The clock time can be automatically set by tings are then saved. means of the RDS signal.
EQUALIZER Adjusting the equalizer Equalizer Press the DEQ button, 6. This device has a parametric digital equaliz- er. In this case, parametric means that in each Select the “LOW EQ”, “MID EQ” or of the three filters, one individual frequency “HIGH EQ”...
EQUALIZER Switching the spectrometer on and off Select “PRESET” with the but- ton, 7. Press the MENU button, 8. To select the preset tone, press the “MENU” appears in the display. button, 7. button, 7, as often Press the Press the OK button, 5. as is necessary for “PEAK ON”...
MiniDisc player or an MP3 player. We recommend that you use matching prod- The AUX input must be switched on in the ucts from the Blaupunkt or Velocity ranges. menu. Switch-on delay for external pre- You need an adapter cable to connect an ex- amplifiers ternal audio source.
TECHNICAL DATA Technical data Amplifier Output power: 4 x 25 Watt sine wave according to DIN 45 324 at 14. 4 V 4 x 45 Watt max. power Tuner Wavebands: FM : 87.5 – 107.9 MHz AM : 530 – 1,710 kHz FM frequency response: 30 - 15,000 Hz Frequency response:...