Connecting The Remote Control Jacks - Marantz SR4003 User Manual

CONNECTING THE REMOTE CONTROL JACKS

INPUT INPUT
1 1
INPUT INPUT
3 3
COMPONENT COMPONENT
VIDEO VIDEO
MONITOR MONITOR
OUT OUT
INPUT INPUT
2 2
DVD DVD VCR IN VCR IN VCR OUT VCR OUT DSS DSS MONITOR OUT MONITOR OUT Y Y C C B B P P / / B B C C R R / / P P R R Y Y C C B B / / P P B B C C R R / / P P R R
3 3 4 4
1 1 2 2
IN IN OUT OUT IN IN OUT OUT OPT OPT
IN IN OUT OUT
DVD DVD VCR VCR DSS DSS TAPE TAPE CD/CDR CD/CDR DIGITAL IN DIGITAL IN DIGITAL OUT DIGITAL OUT REMOTE CONT. REMOTE CONT. REMOTE CONT. REMOTE CONT.
AUDIO AUDIO
AC OUTLETS AC OUTLETS
R R L L R R L L R R L L 120V 120V
FRONT FRONT SURROUND BACK SURROUND BACK SURROUND SURROUND CENTER CENTER
SWITCHED SWITCHED
S. SPEAKER B S. SPEAKER B
1.25A 150W 1.25A 150W
SPEAKER SYSTEMS : 6-8 OHMS SPEAKER SYSTEMS : 6-8 OHMS
CD recorder
REMOTE REMOTE
CONTROL CONTROL
IN IN
OUT OUT
EXTERNAL INTERNAL
2
INPUT 1 INPUT 1
IN IN IN IN
RC OUT
OUT OUT OUT OUT FLASHER FLASHER OPTION
IN IN
AC IN AC IN
60Hz 60Hz
1
MODEL N MODEL NO. SR4003
DVD player CD player
REMOTE
CONTROL
IN
OUT
EXTERNAL INTERNAL EXTERNAL INTERNAL
q
You can control other Marantz products through this
unit with the remote controller by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote controller
is received by the remote sensor on this unit. Then
the signal is sent to the connected device through
this terminal. Therefore you need to aim the remote
signal only to the unit. Also, if a Marantz power
amplifi er (some models excluded) is connected to
one of these terminals, the power amplifi er's, power
switch is synchronized with this unit's power switch.
Set the REMOTE CONTROL SWITCH on the back of
other units (not the SR4003) to "EXT".(EXTERNAL)
to use this feature.
ENGLISH
w
Whenever external infrared sensors or similar
devices are connected to RC-5 IN of the unit, be sure
to always disable operation of the infrared sensor on
the unit by using the following procedure.
1.
Hold down the SURROUND MODE button and
MENU button on the front panel at the same
time for fi ve seconds.
2.
The setting "IR=ENABLE" is shown on the FL
DISPLAY.
3. Press the 1 or 2 cursor button to change this to
"IR=DISABLE".
4.
Press the ENTER button. Once this setting
is made, the infrared sensor on the unit is
disabled.
Note:
Be sure to set to "IR=ENABLE" when external
infrared sensors or similar devices are not connected.
Otherwise, the unit will be unable to receive remote
control commands.
5.
To restore the original setting, perform steps 1
to 4 to set to "IR=ENABLE".
19