Maintenance - Makita 5277NB Instruction Manual

1
1. Rip fence (Guide rule )

MAINTENANCE

1. Limit mark
1. Brush holder cap
2. Screwdriver
1. Breather
2. Gear housing
12
Rip fence (Guide rule) - optional accessory
003633
The handy rip fence allows you to do extra-accurate straight
cuts. Simply slide the rip fence up snugly against the side of
the workpiece and secure it in position with the screw on the
front of the base. It also makes repeated cuts of uniform
width possible.
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out
001521
2
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
1
001528
CAUTION:
1
• Never remove the breather from the gear housing. It is
not an oil cap.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
2
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.