FUNCTIONAL
DESCRIPTION
I(ON)
1. Switch lever
1
1. Adjusting dial
6
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Switch action
004480
O(OFF)
CAUTION:
•
Before plugging in the tool, always check to see that the
1
tool is switched off.
To start the tool, push the "I (ON)" side of the switch lever. To
stop the tool, push the "O (OFF)" side of the switch lever.
Speed change
004481
The blows per minute can be adjusted just by turning the
adjusting dial. This can be done even while the tool is run-
ning. The dial is marked 1 (lowest speed) to 5 (full speed).
Refer to the table below for the relationship between the
number settings on the adjusting dial and the blows per
minute.
Number on adjusting dial
CAUTION:
•
The speed adjusting dial can be turned only as far as 5
and back to 1. Do not force it past 5 or 1, or the speed
adjusting function may no longer work.
5
4
3
2
1
C00148
Blows per minute
2,650
2,450
1,900
1,350
1,100