Rf Modulator Connection - Magnavox ZC352MW8 Owner's Manual

RF MODULATOR CONNECTION

If your TV has antenna in jack only, it is still possible to connect this unit to your TV by using a stereo audio/video RF
modulator. In this case, follow the instructions below.
1) Disconnect the power cords of the devices from the AC outlet.
2) Make the connection as illustrated below.
3) Set your RF modulator's channel 3/4 switch to either 3 or 4, whichever the TV channel is least used in your area.
If your RF modulator has a modulator/antenna switch, set it according to the manual supplied with the RF
modulator.
4) Plug in the power cords of the devices to the AC outlet.
5) Turn on your TV and choose the same channel as you set the RF modulator's channel 3/4 switch to.
For more details, follow the manual supplied with the RF modulator.
VHF / UHF
antenna
or
cable TV
company
Supplied cables used in this connection are as follows:
• RF coaxial cable x 1
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
Note
• The quality of picture may become poor if this unit is connected to an RF modulator.
rear of this unit
IN
RF coaxial cable
OUT
ANTENNA
RF coaxial cable
IN
VIDEO
IN
Y
L L
P B /C B
R R
IN OUT P R /C R
OUT
AUDIO IN COMPONENT
S-VIDEO AUDIO OUT
( E1 ) VIDEO OUT
VIDEO
OUT
L
R
AUDIO OUT
RCA audio cable
rear of your
RF modulator
3 4
R L
ANT. IN CHANNEL AUDIO IN VIDEO IN
Set channel 3 or 4
RCA video
cable
rear of your TV
ANT. IN
RF coaxial cable
TO TV
EN EN 13 13