Magnavox MWR20V6 Owner's Manual page 31

Checking, canceling, or correcting the timer programming
information
1
Press [TIMER SET].
disappears from the front
panel display.
2
Press [TIMER].
Timer Programming list will appear.
Timer Programming
Date Start End CH DVD
VCR
1. JAN/01 12:57AM 1:57AM 8 DVD
2. ---
3. ---
4. ---
3 5. ---
6. ---
7. ---
Check the information on the
8. ---
list you will need.
Note
• Press [TIMER] to check the Timer Recording in process.
- When the Timer Recording is in progress, that program will be highlighted in red.
- While using the side of the unit that is free from Timer Recording (either DVD or VCR) during timer standby
mode, no programs will be highlighted even if you press [TIMER] to confirm the program information. In this
case, you cannot select other program either for correction or add any new programs.
• The unit will be turned on automatically before the recording time.
To stop the Timer Recording in process
Press [STOP C] to stop the disc recording or [STOP C / EJECT A]
to stop the videotape recording on the front panel of the main unit.
[STOP C] on the remote control is not effective.
If the timer program did not complete correctly, the error number
appears in the Timer Programming list.
Timer Programming
Date Start End CH DVD
VCR
*
JAN/01 12:57AM 1:57AM 8 DVD
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
Press [CLEAR/C-RESET] to
erase the selected program.
• A program with the error number is grayed and asterisked in the Timer Programming list.
• Once the Timer Programming list with error line(s) is displayed, or after canceling and setting again the timer
standby mode, the program line(s) with error will be cleared.
Recording
Timer Recording (cont'd)
4
To clear the timer programming:
Using [K / L], select your
desired program. Press [CLEAR/
C-RESET].
To correct the timer program-
ming:
Using [K / L], select your
desired program. Press [OK].
Next, correct the timer
programming by using
VCR DVD
[K / L / { / B].
Mode
Finally, press [OK] again.
HQ
5
Press [TIMER] to exit.
6
Press [TIMER SET] to return to
the timer standby mode.
Each error number means:
VCR DVD
E1- Recording error other than
Mode
E37-39 below
E22
E3-4 Unrecordable disc
E5-6 Copy prohibited program
E9 Disc protected
E30 Disc full
E34 No space for Control
information
E35 PCA full
E36 Already finalized Video
format disc
E40 Some portion has not
been recorded because
of program overlapping.
Recording did not start at the
start time.
•
E7, E8, E31, E3 and E33 are not displayed.
STANDBY-ON
VIDEO/TV VCR DVD OPEN/CLOSE
.@/: ABC DEF
1 2 3
GHI JKL MNO
4 5 6
PQRS TUV WXYZ
7 8 9
CLEAR/C-RESET SPACE TITLE
0
RETURN DISPLAY
4
OK
DISC MENU SETUP
CHANNEL
2
TIMER VCR REC DVD REC REC MODE
TIMER SET SLOW CM SKIP RAPID PLAY
5
SEARCH AUDIO DUBBING
E41 Power failed
E4 No disc when recording
E43 Already 49 titles recorded
E44 Already 54 chapters
recorded
E45 Copy prohibited program
E46 It is impossible to record
additionally on a disc
recorded by other units
when setting Replace Disc
Menu to OFF.
EN
1
6
31