Download Print this page
Dimplex BUH19BWS Installation And Operating Instructions

Dimplex BUH19BWS Installation And Operating Instructions

Hydronic base unit heater

Advertisement

Quick Links

Hydronic Base Unit Heater
Model : BUH19BWS
Dimensions
(millimetres)
110
70
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
IMPORTANT SAFETY ADVICE
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electrical shock, and
injury to persons, including the following:
WARNING - THE SURFACES OF THIS
HEATER CAN BE HOT
If you use this heater in conjunction with
an external thermal control, a programme
controller, a timer or any other device which
switches the heat on automatically, observe all
safety warnings AT ALL TIMES since a fire risk
exists when the heater is accidentally covered
or displaced.
The installation of this product should be carried
out by an electrician or competent person and
be in strict accordance with the latest IEE Wiring
Regulations and relevant Building Regulations.
WARNING - This heater is not equipped with a
device to control the room temperature. Do not
use this heater in small rooms when they are
occupied by persons not capable of leaving the
room on their own, unless constant supervision
is provided.
If the supply cord is damaged, it must be
replaced by a specially prepared cord or
assembly available from the manufacturer or
its service agent.
Before connecting the heater check that the
supply voltage is the same as that stated on
the heater.
The heater must be installed in accordance with
these instructions.
The heater should be installed and operated
in the horizontal position as shown in diagram
above.
The heater should be positioned in accordance
to the clearances stated in these instructions.
465
290
120
475

Installation and Operating Instructions

395
Depth does not
318
include valves and
flexible pipes
90
Rear Support Bracket
22
DO NOT locate this heater immediately beneath
a fixed socket outlet.
WARNING - this appliance must be earthed.
WARNING - do not use this heater in the
immediate surroundings of a bath, a shower or
a swimming pool.
DO NOT COVER THE APPLIANCE or place
material or garments on it, or obstruct the air
circulation around this appliance, for example
with curtains or furniture, as this could cause
overheating and a fire risk.
WARNING - This heater must not be located
immediately below a fixed socket outlet.
CAUTION - Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience or knowledge if they have
been given supervision or instruction concerning
the use of the appliance in a safe way and
understand the hazards involved. Children shall
not play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
Children of less than 3 years should be kept
away unless continuously supervised. Children
aged from 3 years and less than 8 years shall
only switch on/off the appliance provided that
it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning
the use of the appliance in a safe way and
understand the hazards involved. Children aged
from 3 years and less than 8 years shall not plug
in, regulate and clean the appliance or perform
user maintenance.
08/18304/4
320
Ensure grille
inlet air
is clear
Issue 4
Cable
entry
95

Advertisement

loading

Summary of Contents for Dimplex BUH19BWS

  • Page 1: Installation And Operating Instructions

    Installation and Operating Instructions Hydronic Base Unit Heater 08/18304/4 Issue 4 Model : BUH19BWS Dimensions (millimetres) Depth does not include valves and flexible pipes Cable Ensure grille entry inlet air is clear Rear Support Bracket THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE...
  • Page 2: Water Connections

    Installation procedure WARNING - disconnect the heater from the Ensure that all packing items are removed (read any warning electricity supply before undertaking service, labels carefully). Retain all packing for possible use, in the repair or cleaning. event of moving or returning the heater to your supplier. The supply circuit to the heater must incorporate Cutting the aperture in the plinth a double pole isolating switch having a contact...
  • Page 3: Wiring Diagram

    Power supply connection Operation WARNING: THIS APPLIANCE MUST BE EARTHED 1. Switch on the electricity supply to the heater This heater must be used on an AC~ supply only and the 2. Winter use for heating: voltage marked on the heater must correspond with the Set the Winter/Summer switch to (Winter position) supply voltage.
  • Page 4 Your rights under this guarantee are additional to your...