Fuel Management Menu - Lowrance GlobalMap 7200C Operation Instructions Manual

Engine & Configuration menu, Tank Select menu, Tank Size dialog
and Set Configuration button will not be displayed on the Bus Con-
figuration menu.

Fuel Management Menu

The Fuel Management menu gives you access to the following options:
Tank Location, Fuel Added, Add Fuel, Fill Tank, Engine Select, Reset
Calibration, Reset Trip and Reset Seasonal. Those options allow you to
configure, calibrate, reset calibration, reset trip fuel and reset seasonal
fuel for select NMEA 2000 devices. We will cover configuration and cali-
bration procedures later in this section.
Fuel Management highlighted on the NMEA 2000 menu (left).
Tank Location
If you chose an engine-tank configuration with more than one tank, you
will be able to switch the tank location (configuration) in the Tank Lo-
cation menu. When fuel is added to a tank, you will select the correct
tank from the Tank Location menu, then input the amount of fuel
added in the Fuel Added dialog box.
Fuel Added
Used in tandem with the Add Fuel command, the Fuel Added dialog
box allows you to input the amount of fuel added to the tank, when an
amount of fuel is added that does not fill up the tank.
Add Fuel
After entering the amount of fuel added to a tank in the Fuel Added
dialog, the Add Fuel command finalizes the entry of the data. Like the
Fuel Added dialog, the Add Fuel command will only be used when an
amount of fuel is added that does not fill up the tank.
Fill Tank
You will use the Fill Tank command when calibrating a fuel flow and
when filling up the tank without calibration.
Fuel Management menu (right).
127