Travis Industries 864 ST Owner's Manual

Lopi st fireplace owner's manual
Hide thumbs Also See for 864 ST:

Advertisement

Advertisement

Table of Contents
loading

Summary of Contents for Travis Industries 864 ST

  • Page 2 Introduction Important Information Installation Warnings...
  • Page 3 Table of Contents Features Heating Specifications...
  • Page 4 Look for this label: For LPG only | Pout 11” W.C. If the label is present, the heater is equipped for LP (propane). If the label is absent, the heater is equipped for NG (natural gas).
  • Page 5 This Manual...
  • Page 6: Before You Begin

    Before You Begin Location of Controls (front side only) Optional Blower Control Optional Accent Light Pilot Igniter ON/OFF Switch Gas Control Valve Comfort Control Lift the control cover up and swing it forward to access the controls. The Pilot Flame can be found under the center log (it is best viewed at a low level).
  • Page 7: Starting The Pilot Flame

    Starting The Pilot Flame 5 minutes PILOT IGNITER 30 seconds...
  • Page 8: Starting The Fireplace For The First Time

    Starting the Fireplace for the First Time Turning the Fireplace On and Off After the pilot has been started... A switch is provided behind A wall switch may be the control cover (below used to turn the the firebox). fireplace on and off. Adjusting the Flame Height Flame Height Adjustment Knob...
  • Page 9: Adjusting The Optional Blower Speed

    Adjusting the Optional Blower Speed Turn the dial all the way counter-clockwise until it clicks off. Normal Operating Sounds Blower Snap Disk This part can produce a clicking sound as it turns the blower on and off. Gas Control Valve As the gas control valve is turned on and off you will hear a dull clicking sound.
  • Page 10: Maintaining Your Fireplace's Appearance

    Maintaining Your Fireplace's Appearance Yearly Service Procedure Check the walls and ceiling of the firebox for deterioration. Check the burner holes. Make sure the burners are not warped or damaged. Before Disassembly - Check the pilot flame (it can be viewed from the front - you will need to look under the center log).
  • Page 11: Grill Installation And Removal

    Grill Installation and Removal Upper Grill Installation Hold the grill at an angle and insert the lower slot over the bushing on the fireplace (both sides). You may need press on the grill to get the tab over the bushing (this prevents the grill from accidentally falling off).
  • Page 12: Face Installation And Removal

    Face Installation and Removal Phillips Screwdriver Four screws hold the face in place. The screws are accessed through the grills on the face.
  • Page 13: Glass Frame Removal And Installation

    Glass Frame Removal and Installation Based upon the face being used, either: (a) swing the access door down and remove the top grill, (b) remove the face (unscrew or lift off - see the instructions included with the face for details). Open the four latches holding the glass frame in place (start with the bottom three) - follow the directions shown to the right.
  • Page 14 Glass Frame Removal and Installation (continued) The latch can come loose from glass frame anchor. This occurs when it is turned 1/4 turn when it is disengaged. Follow the directions below to re-install the latch if it becomes loose. Hold the latch at an angle and insert it into the slot on the glass frame anchor. Latch Glass Frame Anchor...
  • Page 15: Log Set Installation

    Log Set Installation...
  • Page 16: Center Log Installation

    Center Log Installation The log shelf has two tabs used to align the center log. Bend these tabs as shown to the right. Place the center log in place. Make sure the two tabs on the log shelf insert into the two holes on the bottom of the log.
  • Page 25: Glass Cleaning

    Glass Cleaning A tab at each corner of the glass assembly holds the inner glass frame to the outer glass frame. With the outer glass frame and screen removed, the outer surface of the glass may be cleaned. NOTE: when re-attaching the outer frame, bend the tab inwards 30°(do not over-bend) Inner glass frame Outer glass frame...
  • Page 26: Troubleshooting Table

    Troubleshooting Table...
  • Page 27: How This Fireplace Works

    How this Fireplace Works When heated, the thermopile generates electricity (a very small amount measured in "Millivolts"). Pilot Flame The pilot flame is a time-proven component that eliminates the possibility of gas buildup inside the firebox. Thermocouple The thermocouple generates a small amount of electricity.
  • Page 28: Wiring Diagram

    Wiring Diagram On/Off Switch (black) Power In Common Molex (white) Connector Ground (green) Optional Blower(s) Gas Control Valve Optional Regulator Solenoid Replacement Parts List Thermocouple Thermopile Brown Copper Co-Axial Wire White Optional Thermostat Black White Green Ground (attached to stove) White Black Brown...
  • Page 29 Check with your dealer in advance for any costs to you when arranging a warranty call. Mileage or service charges are not covered by this warranty. This charge can vary from store to store. Exclusions Exclusions Exclusions Adjustable Air Restrictor, Pressure Relief Mechanisms, Barometric Control Mechanism (for models with Remote Heat Ducts), Glass Attachment Mechanism...
  • Page 30 Accessories...

This manual is also suitable for:

Lopi 864 st

Table of Contents