Global Setup; System Reset - Uniden WDECT 2300 Quick Start Manual

UP349BH (WDECT2300) ENG OM
[ 12 ]
1/5/05 1:18 PM Page 12

Global Setup

If you change one of the Global settings, you change the setting for all additional
handsets. Only one handset can change Global settings at a time.
Submenu name
Day & time Set the day and time of your display (see page 17).
Name Tag (POP ID) Display the stored name with the Caller ID telephone number, if the displayed
(Default is on) Caller ID telephone number is exactly the same as a number stored in the
phone book (see page 17).
Insert 0 Add "0" or "00" to the number, when you receive the Caller ID message
(New Zealand only) (see page 17).
Dial Mode Set the dial mode to tone or pulse (see page 18). Most phone systems use tone
(Australia only) dialing, which send DTMF tone through phone line. The default is tone dialing.
(Default is tone) Depends on your dialing system, set the dial mode.
Copy Phonebook Allow you to transfer the phonebook data stored in one handset to another
handset (see page 18).

System Reset

System Reset is used to clear the handset's ID from the main base unit, or the
base ID from the handset.
Submenu name
Deregister HS Clear the handset ID from the base. Use this option, for example, when you change
the digital security code (see page 19).
Replacing Base Clear the base ID. Use this option, for example, if you wish to deregister the base
to use the handset with another base of the WDECT2300 series (see page 19).
Description
Description