Linear PERS-2400 PERSONAL EMERGENCY REPORTING SYSTEM RA-2400 Programming Manual page 37

5.3 CONNECTING TO A CONSOLE (CONTINUED)
CONNECTING LOCALLY
!
Verify that the modem's LINE jack is connected to the Console's
LINE jack with a double-ended modular telephone cable.
!
Verify that the Console is in TEST MODE (press the test button to
set the Console into Test Mode).
!
Click the CONNECT button. The Communication Status area will
show the progress of the connection. WAIT UNTIL THE TIMEOUT
TIMER BEGINS TO COUNT DOWN BEFORE PROCEEDING.
!
As the timeout timer counts down, PRESS THE EMERGENCY
BUTTON ON THE CONSOLE.
CONNECTING REMOTELY
!
Be sure that the modem's LINE jack is connected to a working
telephone line.
!
Verify that the Console's LINE jack is connected to a working
telephone line.
!
Click the CONNECT button. The Communications Status area will
show the progress of the connection. WAIT FOR THE
CONNECTION TO COMPLETE. The RA-2400 will dial the number
once, wait for a few rings, hang-up, then dial a second time. The
Console should answer the telephone immediately when the
telephone rings during the second dialing attempt.
After connecting the Communications Status area will show the progress
of the on-line connection, then display "Connected" and the Personal
Emergency System version number.
The Console Power area will show the status of the Console's AC power
and backup battery. Pressing the REFRESH button will update the
displayed information and display the console version number.
Local Connection in Progress Remote Connection in Progress
35