Install The Log Assembly - Heat & Glo SL-550TR-E Owner's Manual

F. Install the Log Assembly
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
Note: Figure 1 illustrates the recommended gap between the
burner and the lava rock retainer.
Carefully remove the logs from the packaging.
CAUTION: Logs are fragile!
Indentation Indentation
Figure 2 Figure 2
Left rear log tab Left rear log tab
Indentation Indentation
Figure 4 Figure 4
Log #1: Locate the slot on the bottom right side of log 1.
Mate the slot with the right rear log tab. Pull the left end of
log #1 forward until it touches the left rear log tab.
66
1 1
Slot Slot
1 1
Mate slot with tab Mate slot with tab
Heat & Glo • SL-550 / 750 / 950TR-E • 2118-900 Rev. U • 7/12
Log Set Assembly: LOGS-550-E, 750-E, 950-E
Model: SL-550TR-E, 750TR-E, 950TR-E,
SL-550TV-E, SL-750TV-E, SL-950TV-E
3/8 in.
No lava rock
may be placed
past this edge.
Figure 1
Left rear log tab Left rear log tab
Shoulder screw Shoulder screw
Lava Rock retainer Lava Rock retainer
Figure 3 Figure 3
Log # 2 should touch fi rebox Log # 2 should touch fi rebox
2 2
Mate notch with grate tine Mate notch with grate tine
Figure 5 Figure 5
Log #2: Mate the left grate tine with the notch located on
the left end of log #2. The right end of log #2 should rest
on log #1 as shown. Be sure that the top of log # 2 touches
the back of the fi rebox.
Burner
Lava Rock
retainer
Right rear log tab Right rear log tab
Grate tine (4) Grate tine (4)
2118-935D 6/07