Chopper Technology Fundamentals - Lincoln Electric VANTAGE 400 Service Manual

Lincoln electric welder user manual
Hide thumbs Also See for VANTAGE 400:
Table of Contents

Advertisement

E-7
CHOPPER TECHNOLOGY
FUNDAMENTALS
The new era of welding machines such as the
Vantage® 500, employ a technology whereby a DC
source is turned on and off (chopped up) at high speed,
then smoothed through an inductor to control an arc.
EXTERNAL
DC SOURCE
In this system, the engine drives a three-phase alter-
nator, which generates power that is rectified and
filtered to produce about 75VDC.
applied through a solid state switch to an inductor. By
70-80VDC
When the switch is closed, current is applied through
the inductor to the arc. When the switch opens, current
stored in the inductor sustains flow in the arc and
through the diode. The repetition rate of switch closure
is 20Khz, which allows ultra-fast control of the arc. By
THEORY OF OPERATION
Hence the name "Chopper." The biggest advantage®
of chopper technology is the high-speed control of the
arc, similar to the inverter machines. A block diagram
for this is as follows:
SOLID STATE
SWITCH
ARC
CONTROL
turning the switch on and off, current in the inductor
and the arc can be controlled. The following diagram
The current is
depicts the current flow in the system when the switch
is open and closed.
SWITCH
DIODE
CURRENT WITH SWITCH CLOSED
varying the ratio of on time versus off time of the switch
(Duty Cycle), the current applied to the arc is con-
trolled.
Controlling the switch in such a way as to produce
superior welding.
VANTAGE® 400
INDUCTOR
AND DIODE
INDUCTOR
ARC
CURRENT WITH SWITCH OPEN
This is the basis for Chopper Technology:
E-7
ARC

Advertisement

Table of Contents
loading

Table of Contents