Lincoln Electric PRECISION TIG 225 Operator's Manual page 33

Lincoln electric welder user manual
Hide thumbs Also See for PRECISION TIG 225:
Table of Contents

Advertisement

E-6
PROBLEMS
(SYMPTOMS)
No high frequency. Machine is in the
TIG Mode and has normal output.
No gas flow when Amptrol is activat-
ed in the TIG Mode. Machine has
output - fan runs. A "Click" can be
heard indicating that the gas sole-
noid valve is operating.
When AC TIG welding, the arc is
erratic and there is a loss of "clean-
ing" of the work piece.
The end of the tungsten electrode
melts away.
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.
TROUBLESHOOTING
Observe all Safety Guidelines detailed throughout this manual
POSSIBLE
TIG WELDING PROBLEMS
1. If the machine location is in a
highly dirty environment with con-
ductive contaminants, check and
clean the spark gap with a low
pressure air stream per the main-
tenance instructions.
2. Check spark gap operation and
setting. Normal is (0.020"). Refer
to Maintenance section of this
report.
1. Gas supply is empty or not turned
on.
2. Flow regulator may be set too
low.
3. Gas hose may be pinched.
4. Gas flow may be blocked with
dirt. Check filter screen inside gas
inlet fitting to solenoid valve. Use
filters to prevent reoccurrence.
5. Consult your local welder/gas dis-
tributor.
1. Tungsten electrode may be too
small for process. Use a larger
diameter tungsten or a pure tung-
sten.
2. If a helium blend is used as a
shielding gas, then reduce the
percentage of helium.
1. The welding current is too high
for the electrode type and/or size.
See Electrode Amperage Ranges
in the Operation Section of this
manual.
PRECISION TIG 225
CAUSE
If all recommended possible areas of
misadjustment have been checked
and the problem persists, Contact
your local Lincoln Authorized
Field Service Facility.
CAUTION
RECOMMENDED
COURSE OF ACTION
E-6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Precision tig 225 ip 21s

Table of Contents