Binatone Cliptel 50 User Manual

page 8

Troubleshooting

The Cliptel 50 must be serviced by trained engineers. NEVER
attempt any repairs or adjustments yourself — you could make
the problem worse and invalidate the Guarantee.
Always make sure your Cliptel 50 is fully plugged into the
telephone line socket.
If the phone does not ring ... Check that the ringer volume switch on the side of the
n
handset is not set to OFF.
Check that the total REN value of all equipment connected to
n
your telephone line is no more than 4. Disconnect one or
more telephones and see whether that helps.
If you cannot make calls ... Disconnect all other instruments connected to the same line
n
as the Cliptel 50 and see whether you can make a call.
Disconnect the Cliptel 50 from the telephone line and plug a
n
different telephone into the socket. Try making a call. If this
works, the line is OK.
If you are using a two-way socket adapter, remove it and
n
plug a telephone directly into the socket. If the call now
works, the adapter may be faulty.
If you think the fault may be on the exchange line, contact
n
the service provider (the BT engineers on 151, or your cable
company).
If you still cannot identify the cause of the problem, contact
n
the Binatone Help Line.
Technical details
Temperature range
Approvals
PBX compatibility
Do not clean any part of
your Cliptel 50 with solvent
chemicals, abrasives or
spray cleaners which might
get inside the case and
The five numbers stored in the Redial memories can have up to
cause damage not covered
32 digits each.
by the guarantee. When
necessary, clean it with a
Binatone Telecom plc operates a policy of continuous product improvement,
damp cloth.
and so reserves the right to make changes to the product and functions
Keep your Cliptel 50 away
without notice
from hot, humid conditions
or strong sunlight.
If you need help, call the Binatone Help Line
020 8 344 8870
9.00 am to 5.00 pm, Monday to Friday
Operating 0ºC to 40ºC
Storage -20ºC to 60ºC
ETS 300-001, PD7010
100 ms timed break recall
Pause length: 3 seconds
Signalling type: DTMF (dual tone multi-
frequency), also called tone dialling
.
page 1
SECRECY button
Press this during a call to prevent
the caller from hearing you.
Press it again when you want to
be heard again.
Ringer volume control
OFF–LOW–HIGH
If this is set to OFF, the
phone will not ring.
'NEW CALL' light
This flashes when there has been an incoming call, until you have
checked the caller's ID. It is on steadily when you are dialling on-hook.
new call
Display
11-05-52a
When the handset is on hook, this shows the time.
See page 3 for more details of display symbols and messages.
PHONE BOOK button
For storing, calling and deleting numbers
phone book
in your 50-number Phone Book
OK C
MENU buttons
... shown in the instructions like this
UP DOWN
The MENU buttons take you through a
range of options on the display, as shown —
Press or to bring the menu up on the display, and
CALLER ID
menu options
You can do this with the handset on-hook or off-hook.
KEYBEEP
Press OK to select the option on the display, and go to the next level
BABYCALL
For details of each feature, see the relevant page of this guide.
SETTINGS
Press to move back one level and to quit 'menu mode'
C
... or you can simply replace the handset to quit.
TIME ACCT
...
phone will automatically quit 'menu mode' and show the time.
STORE
THE DISPLAY MAY BE BLANK FOR A FEW MOMENTS BEFORE SHOWING THE TIME.
Cliptel 50

USER GUIDE

Hook switch
RECALL button
You will need this if your phone is
connected to a PBX, or if you use BT's
Select Services.
PAUSE button
You may need this if your phone is
connected to a PBX.
One-touch memory buttons
REDIAL button — press this to display the
last number you dialled.
For Multi-Redial , you can then press
(see below) to scroll through the last five
dialled numbers.
When the number you want is shown on the
display, press to dial it.
OK
While you are using these
buttons, your line will be
Busy, even if the handset is
on hook.
Ignore any recorded
messages or
from the exchange.
to scroll through the
or if you wait for one minute without pressing a button, the
Model 2982
or
tones you hear