Ariens Sno-Thro 932105 - 8526 , 932506 - 8526 Owner's/Operator's Manual page 14

Throttle
The throttle controls the engine
1
speed. To increase or decrease
the engine speed, adjust to:
2
1. Fast (normal or warm starts)
2. Part-Throttle
3. Slow (cold weather starts)
3
4. Stop (engine is off)
4
OL2720
Electric Starter (932105)
The electric starter will start a properly choked
and cranked engine when the starter button is
pushed. Refer to Starting and Shut-Off.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back
against starter.
Snow Clean-Out Tool
WARNING: Hand contact with the
rotating impeller is the most common
cause of injury associated with snow
throwers. Never use your hand to
clean out the discharge chute.
To clear the chute:
1. Shut off the engine.
2. Wait 10 seconds to be sure impeller
blades have stopped rotating.
3. Remove the snow clean-out tool (1) from
the auger housing and use it to remove
the clog.
4. Replace the snow clean-out tool on the
auger housing.
Deflector Remote
Place deflector into position before operation.
DO NOT throw snow any higher than
necessary.
Push deflector remote forward to throw snow
lower. Pull deflector remote back to throw
snow higher.
Discharge Chute
Discharge chute rotates 215°.
ALWAYS position discharge chute in safe
direction and angle, away from operator and
bystanders, before starting engine.
Chute Crank
IMPORTANT: If chute does not stay in set
position, adjust as directed in Service and
Adjustments, or repair before operation.
Rotate the Chute with Discharge Chute Crank
Handle.
IMPORTANT: DO NOT force frozen chute
controls. Start engine and run for 3-5 minutes
to thaw. If still frozen, take to warm place until
controls are free.
Axle Lock Pin (Figure 9)
Use the axle lock pin to lock or unlock the right
wheel. Lock the right wheel to increase
traction; unlock the right wheel to allow for
easier turning of the unit.
1
GB - 14
Wheel Unlocked
Wheel Locked
Figure 9
Axle
Lock
Pin