About Memory; Using The Monitor With Ac Adapter - LifeSource UA-767 Plus Instruction Manual

Advanced/deluxe one step auto-inflation
Hide thumbs Also See for UA-767 Plus:
Table of Contents

Advertisement

ABOUT MEMORY

This monitor automatically stores up to thirty (30) blood pressure and pulse
measurements in memory. Measurements stored in memory are assigned an
index number in the order of the newest to the oldest. The oldest reading dis-
plays as "n01". The M symbol in the upper left corner of the display screen
indicates that you are viewing a previous measurement stored in memory.
To retrieve readings, follow these simple steps:
1.
When the display screen is blank, press and quickly release
the Memory ("M") button. You will see the index number
of the most recent reading followed by the measurement.
2.
If you want to retrieve other measurements in memory,
press and release the Memory button repeatedly until the
desired index number is reached (e.g. n04). The measure-
ment will then be displayed.
3.
The display will shut off automatically a few seconds after
the readings are displayed.
To clear the measurement history from memory, press and hold
the Memory button for at least five seconds while the display
screen is blank. Release the button when you see the M symbol
flash and disappear in the upper left hand corner of the display.
This indicates that the memory has been cleared.
If there are no measurements stored in memory, you will see two 0s displayed
vertically followed by a blinking "A00".
NOTE: Stored measurements will be lost if batteries become low or are
removed.
E-10
LifeSource Health Line (Toll-Free): 1-888-726-9966

USING THE MONITOR WITH AC ADAPTER

The UA-767 Plus has an AC adapter jack to allow you to supply power
from an outlet in your home. We recommend you use only the exclusive
AC adapter to avoid potential damage to the monitor. Please contact A&D
Medical at 1-888-726-9966 (in Canada - 1-800-463-5414) if you would like
to purchase the AC adapter.
Connecting the AC adapter to the monitor:
1.
Gently insert the AC adapter plug into a 120V AC outlet.
2.
Connect the AC adapter plug into the jack on the right side
of the monitor.
Disconnecting the AC adapter from the monitor:
1.
Turn the unit off by pressing the START button.
2.
Disconnect the plug from the jack of the monitor quickly.
3.
Gently remove the AC adapter from the outlet.
NOTE: If monitor has batteries-installed and an AC adapter connected, the
measurements stored in memory will be lost if AC adapter is unplugged
from the wall first. To ensure that measurements remain in memory, make
sure the unit is off and that the jack plugged into the monitor is removed
quickly before unplugging adapter from the wall.
Jack
Plug
In Canada - Auto Control Medical (Toll-Free): 1-800-461-0991
AC Adapter
Jack
E-11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents