Table of Contents
Advertisement
5
4
1, 3
2, 3
OS7030
1. Wing Knobs
2. Wing Nut
3. Bolt
Figure 5
Install Discharge Chute and
Discharge Chute Crank (921004, 006,
007, 008, 009)
(Figure 6)
1. Grease underside of discharge chute
ring (if not already greased).
2. Remove mounting hardware from auger
housing.
3. Install discharge chute over opening in
the auger housing. Finger tighten the
mounting hardware removed in step 2.
NOTE: Leave discharge chute pedestal loose
to help install the chute rod and connect it to
the control assembly.
1
4. Shift Rod
5. Speed
Selector
Lever
GB - 9
OS7040
4
1. Mounting
Hardware
2. Discharge
Chute
(Figure 7, Figure 8)
4. Remove the cover from the gear
assembly on the discharge chute.
5. Release the lock teeth on the gear
assembly with your finger and rotate the
discharge chute 90
6. Remove and save the hairpin from the
control assembly underneath the control
panel.
NOTE: Do not remove the pin installed on the
chute rod.
NOTE: To ensure the discharge chute follows
its full range of travel, make sure the control
lever is pushed all the way to the left before
installing and pinning the chute rod.
7. Align the holes on the end of the chute
rod with the mark on the gear assembly
and slide the end without a pin through
the gear assembly, through the hook on
the chute lock cable and into the hex
hole in the control assembly.
IMPORTANT: The hook will prevent the
control cable from contacting the engine or
muffler guard.
1
2
OS7045
3. Chute
Pedestal
4. Discharge
Chute Ring
Figure 6
°
left.
3
1
Hide quick links:
Advertisement
Table of Contents
