GE Tetra GEPS12-180U Installation Manual

GE
Lighting Solutions
Tetra LED Systems Power Supply
®
(GEPS12-180U)

Power Supply Features

• Supports Tetra miniMAX, Tetra MAX, Tetra PowerMAX,
Tetra PowerStrip and Tetra miniStrip lighting systems
• Class 2 wiring per NEC Article 725 (SELV equivalent)
• Damp location rated
• IP66 rated: separate enclosure required
• Three 60 watt output banks

BEFORE YOU BEGIN

Read these instructions completely and carefully.
RISK OF ELECTRIC SHOCK:
• Disconnect power at fuse box or circuit breaker before servicing or
installing product.
• Properly ground Tetra power supply.
®
RISK OF FIRE:
• Use only Tetra supply wire to make connection from Tetra
®
supply to Tetra LED strip.
®
• Use only approved wire for input/output connection.
Minimum size 18 AWG (0.82 mm
• Follow all local codes.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. This Class [A] RFLD complies with the Canadian standard ICES-005. Ce DEFR de la classe [A] est conforme à la NMB-005 du Canada.

Power Supply Installation

Mount power supply and remove
1
junction box cover. Carefully remove
knockout for AC line input wires.
Install appropriate electrical fittings
in the knockout holes for wire
protection.
imagination at work
WARNING/AVERTISSEMENT
power
®
)
2
To Tetra LED System
Output wires
Connect the supply wire that is
2
attached to the Tetra LED System to
the red (+) and black (-) output wires
of the power supply as outlined in
the "Electrical Connections" section
of your LED system's Installation
Instructions.
NOTE: Three 60 watt output banks per
power supply. Do not interconnect
output terminations.
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l'alimentation électrique à la boîte de fusibles ou au
disjoncteur avant l'entretien ou l'installation du produit.
• Assurez-vous de correctement mettre à terre l'alimentation
électrique Tetra .
®
RISQUES D'INCENDIE
• N'utilisez que le fil d'approvisionnement Tetra
connexion entre l'alimentation Tetra
• N'utilisez que des fils approuvés pour les entrées/sorties de
connexion. Taille minimum 18 AWG (0.82 mm
• Respectez tous les codes locaux.
White
(neutral)
Connect the AC line to the black
3
(line) and white (neutral) input
wires of the power supply using
18-14 AWG (0.82-2.08 mm
wire connectors. Ground power
supply by connecting green wire
with yellow stripe to grounding
screw. Replace junction box cover.

Installation Guide

12
Volt
pour faire la
®
et la bande DEL Tetra .
® ®
).
2
Green with
yellow stripe
(ground)
AC line
Black (line)
) twist-on
2