Trane X13511537-01 Setup Instructions

Setup Instructions
Trane Programmable Thermostat
X13511537-01/BAYSTAT150A/THT02774
More information:
https://www.trane.com/stat
SAFETY WARNING
Only qualified personnel should install and service the equipment.The
installation, starting up, and servicing of heating, ventilating, and air-
conditioning equipment can be hazardous and requires specific
knowledge and training. Improperly installed, adjusted or altered
equipment by an unqualified person could result in death or serious
injury. When working on the equipment, observe all precautions in the
literature and on the tags, stickers, and labels that are attached to the
equipment.
March 2012
© 2012Trane.
All rights reserved.
2

Fan Mode

The fan mode is displayed only on systems configured with the fan
enabled.
For systems configured with a fan, the fan setting is shown on the
display. In addition, the setting also appears on the display when
pressing , , from the Home screen.
The fan mode setting can be overridden by pressing
fan mode flashes. Press and hold
Save and Exit. Refer to the section,
Auto Mode:
Auto Flashes
Important: When this thermostat is configured in
programmable mode (0140=1), then changing the Fan
Mode from the Home screen puts the thermostat into
Timed Override (TOV) and is only temporary.The fan
goes back to the schedule setting after theTOV timer
expires.
X39641168-01B
or when the
for 2 seconds or wait 10 seconds to
"Timed Override (TOV)".
On Mode:
Arrows Flash
1
Time Setup
To change the current time:
1. From the Home screen, press
2. Press , , or to scroll between hours and minutes.
AM
Hours Minutes
1. Press to increase or
AM
Changing Hours
1. Press and hold for 2 seconds or wait 10 seconds to Save and Exit.
System Mode Setup
To set the system mode:
1. From the operating screen, press
2. Press or to select a mode.
Emergency Heat Cool
Heat
Note: Not all system choices may be available depending on the
system configuration 0130.
3. Press and hold for 2 seconds or wait 10 seconds to Save and Exit.
3
Timed Override (TOV)
A timed override can be used to temporarily change the heating setpoint,
cooling setpoint, fan mode, and/or occupancy setting from the
programmed schedule.The override can be set for up to 99 days and up
to 23 hours.
To enter a timed override:
1. From the operating screen, press
enters timed override mode with the hourglass
flashing.
2. Press or press or
the selections. Some of the selections may not be available
depending on the system type.
Cooling Fan Occupancy
Setpoint Setting Setting
3. Press or to change the value of the currently active (flashing)
selections. Repeat steps 2 and 3 for the desired settings.
Note:To reach the DAYS setting, the user must press
hours setting.
4. Press and hold for 2 seconds or wait 10 seconds to Save and Exit.
Note: The thermostat will return to the scheduled operation when:
• the override time expires, or
• pressing and holding
Important: When in timed override mode, if the system
selection is changed (EmHeat, Heat, Cool, Auto, OFF), this
change will take the thermostat out ofTOV mode.
Important: Whenever the thermostat is inTOV mode, a
solid hour glass ( ) indicator displays at the bottom of the
screen.
, , , , , .
PM
to decrease the hour or minute.
PM
PM
Changing Minutes
, .The current mode flashes.
OFF
Auto H/C Off
or 2 times.The thermostat
and setpoint
to move from either left or right through
DAYS HOURS
(Days)*
Hours Heating
Setpoint
an for 2 seconds.
PM
from the