Log Set Installation Instructions - Lennox Hearth Products Winslow (PS40) Installation And Operation Manual

Log Set installation Instructions

Kit Contents
Part #H514
Qty
(1) left log (B)
(1) right log (C)
(1) front log (D)
(2) log support brackets (E)
B
Figure 38
Tools Required:
None
CAUTION: The logs can be damaged if they are not handled
with care!
To Install the log set:
1. Remove the two log support brackets from the box and bend the ends
of the brackets 90 degrees at the cut lines. See Figure 39.
2. One bracket goes into the left corner and the other into the right corner
of the firebox. Rotate the brackets so they are placed as shown in
Figure 40. The bracket fits between the back of the firebox and the
air wash at the front of the stove.
3. Remove the ceramic logs from the box and carefully unwrap them.
Position each back log (Figure 41, B and C) in their proper place, one
on each side against the back of the firebox.
4. The front log should face the front of the firebox with the woodgrain
showing. It should rest on the other two back logs. See Figure 41
for assembled log set.
18
C
D
E
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 39
E
Figure 40
B
Figure 41
cut lines
Bracket correctly placed
C
D