Draft Adjuster; Wiring Diagram - Lennox Hearth Products Winslow (PS40) Installation And Operation Manual

Draft Adjuster

The Winslow™ PS40 stove has a draft adjuster located at the left side
of the stove directly in front of the combustion blower. Should the stove
installation require long runs of vent pipe, a situation may be created
where excessive combustion air is flowing through the firebox and
causing the fuel to burn faster than it can be delivered to the Burn-Pot.
Should this happen, the draft can be slowed down by the adjuster. The
stove is shipped with the adjuster in the fully open position. To slow the
draft down, loosen the 5/32" allen head screw (A in Figure 54) and move
the adjuster handle toward the center of the stove. Retighten the screw
when the desired adjustment is reached.

Wiring Diagram

10
YEL
5
ORNG
GRAY
YELLOW
Figure 55
6
9 8 7
6
RED WHT GRY
BRWN
4 3 2
VIOL
BLK GRN BLU
Molex 10 Pin Connector
BLACK
RED
BLOWER
SNAP SWITCH
ROOM AIR
(CONVECTION) BLOWER
WHITE
WHITE
BLACK
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Draft Adjuster
Figure 54
1
ORANGE
BROWN
GREEN
BLUE
VIOLET
IGNITER
OVER TEMP
SNAP SWITCH
AUGER
MOTOR
BUS
GREEN
Draft Adjuster
PROOF OF
FIRE SNAP
SWITCH
BROWN
COMBUSTION
BLOWER
WHITE
GROUND
A
VACUUM
SWITCH