Brick Panel Installation Instructions - Lennox Hearth Products Winslow (PS40) Installation And Operation Manual

Brick Panel Installation
Option: Part #79030
Kit Contents:
- Brick Panel (A)
- 4 Tap Tights (B)
Tools Required:
- Drill (90° drill recommended)
- #18 drill bit
- 5/32 allen wrench
A
Figure 33
Note: The brick panel comes pre-painted with Metallic Black paint. The
brick panel may be painted with any color of high-temp paint (paint
may discolor with use).
1. Remove the front door of the pellet stove. To remove the front door,
open the two side panels, swing open the front door and lift it up
and off of its hinges. Remove the optional log set, if present and the
Burn-Pot.
Figure 34
16
B
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
2. Remove all pellets and ash from the firebox to ensure a proper fit for
the brick panel.
3. Insert the brick panel, top first, as shown in Figure 35. The two cut
out corners should be at the bottom.
Figure 35
4. Make sure that the brick panel is centered, with equal space on either
side of the auger tube. While holding the panel in place, use the drill
with a #18 drill bit to drill out the four holes in the back of the firebox, as
shown in Figure 36.
Figure 36