Door Grill Installation Instructions - Lennox Hearth Products Winslow PI40 Installation And Operation Manual

Door Grill Installation Instructions

Parts Needed
Qty
(4) Button Head Screws (already in place in insert)
Tools Required:
1/8" allen wrench
To install the Grill:
1. Remove the four button head screws from body of the insert with a
1/8" allen wrench. See Figure 21.
Figure 21
2. Pull the scraper rod out, rotate the grill vertically, (with the notch to
the left) and slide the grill over the scraper rod (slide the rod between
the third and fourth bar). See Figure 22.
Notch
Slider Rod
Between 3rd & 4th Bar
Figure 22
14
Remove Button Head Screws
( places on each side)
Button Head Screw
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
3. Rotate the grill back to the horizontal position and re-install the four
button head screws through the two holes at each end of the grill and
into the insert body. See Figures 23 and 24.
Rotate Grill Back To Horizontal Position
Figure 23
Re-install Button Head Screws
Figure 24
IMPORTANT
If you have a gold or nickel grills, be sure to clean
them with a soft cloth and household glass cleaner
prior to burning the insert. Fingerprints left on the
plated surfaces while burning will usually remain
on the finish permanently.