Advertisement
Quick Links
INSTALLATION INSTRUCTIONS FOR OUTDOOR BI-FOLD GLASS DOORS
These bi-fold glass door assemblies have been designed for use with and
may be easily fitted to your Lennox Outdoor Gas Fireplace, Models
E36ODG & E42ODG.
Do not alter or modify these door assemblies or a fireplace malfunction
or a fire hazard may result.
These doors have been tested and listed by Omni-Test Laboratories
Inc.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
GENERAL INFORMATION
The door assembly consists of a right and left glass panel assembly with the
door handles factory mounted. Included is a four piece door frame with
eight (8) screws and a hood (hood packaged separately), which are required
for assembly. Fireplaces listed on the front page of this document, have
been designed to accept these doors with minimum effort.
TOOLS REQUIRED
• Medium Phillips Screwdriver • 3/8" Open-end wrench
• 1/4" Drive Socket
MODELS: 36BFOD-BS & 42BFOD-BS
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE
750,210M
Rev. A 07/2006
INSTALLATION INSTRUCTIONS
Remove Screens And Rods:
Using a 5/16" socket or nutdriver, remove the screen rod assemblies
(see Figure 1 ). Remove the screen rod screws as shown in Figure 1 .
Pull out the rods from locating holes on the side of the firebox opening.
IMPORTANT! REINSTALL SCREEN ROD SCREWS INTO THE EXISTING
HOLES WHERE REMOVED.
The screen and rod assemblies must not be installed when the Bi-Fold
Glass Door Kit is installed. You may wish to retain the screen and rod
assemblies is case the Bi-Fold Glass Door Kit is ever removed in the future.
IMPORTANT! IF THIS OPTIONAL BI-FOLD GLASS DOOR KIT IS EVER
REMOVED, THE ROD AND SCREENS MUST BE REINSTALLED FOR
SAFE OPERATION OF THE APPLIANCE.
Screen Rod
Screws
Figure 1
FIREPLACE KITS
AND ACCESSORIES
BI-FOLD GLASS DOORS
Screen And
Rod Assembly
1
Advertisement
Related Manuals for Lennox Hearth Products Bi-Fold Glass Doors 36BFOD-BS
Summary of Contents for Lennox Hearth Products Bi-Fold Glass Doors 36BFOD-BS
- Page 1 INSTALLATION INSTRUCTIONS FOR OUTDOOR BI-FOLD GLASS DOORS These bi-fold glass door assemblies have been designed for use with and may be easily fitted to your Lennox Outdoor Gas Fireplace, Models E36ODG & E42ODG. Do not alter or modify these door assemblies or a fireplace malfunction or a fire hazard may result.
- Page 2 Hood Installation: Begin the assembly by installing the hood (packaged separately). Be certain to remove any protective plastic coatings for the stainless steel parts before installing those components. Step 1. Turn off the fireplace and allow it to cool before proceeding. Step 2.
- Page 3 Lower Pivot Pin Figure 6 Step 2. Tilt the top of the door into place and carefully ensure that the upper pivot pin and roller pin is in the upper door guide track. Step 3. Continue to tilt the top of the door into place until the upper pivot pin engages the spring clip and the pivot pin locks into place within the hole of the spring clip ( see Figure 7 ).
- Page 4 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2006 by Lennox Hearth Products P/N 750,210M REV.