LENCO HP-2010 Specification Sheet

LP-2000
• Star weld tip welds directly to the work piece
• Built on slide hammer for one step operation
• Can shrink light gauge metals
• Available with primary voltage of 208/230 single phase 50/60
Hz, 20 amp or 120 volts 50/60 Hz, 30 amp
• 7' welding & 7' ground cable leads
• Shipping weight is 64 lbs.
• 25' Power cable
Model Item Code No.
LP-2000 20720
LP-2000 20820
The LENCOSPOT MARK II
The Mark II welder makes factory type spot welds in the shop. Simple to operate
by pressing the two electrodes against the work and pressing the trigger.
• Time of welds is automatic by solid state electronics
• Protected control panel
• On/Off indicating switch
• Maximum welding capacity is 20 ga. autobody steel
• Tool storage space
• Easy portability with wheeled car t
• Primary voltage is 208/230 single phase 50/60 Hz,
50 amp or 480 single phase 50/60 Hz, 30 amp
• Shipping weight is 110 lbs.
• 50' Power cable
Model Item Code No.
L-4000 20400
L-4480* 20480
*w/o power cable
RESISTANCE SPOT WELDERS
LENCOPULL Portable Dent Pulling Systems
Lenco dent pulling systems allow for
any type of pull in any situation.
Systems have their own specially
designed transformers and are
available in 120 or 230 VAC.
Volt Capacity
208/230
120
®
Volt Capacity
208/230
480
...
• T-handle can be used for short controlled pulls
• Lightweight, padded grip for comfortable usage
• Can shrink light gauge metals
• Available with primary voltage of 208/230 single phase 50/60
Hz, 20 amp or 120 volts 50/60 Hz, 30 amp
• 10' welding & 7' ground cable leads
• Shipping weight is 64 lbs
• 25' Power cable
Model Item Code No.
HP-2010 20710
HP-2010 20810
®
HP-2010
Volt Capacity
208/230
120