Advertisement
Quick Links
TX7U Outdoor Temperature/Humidity Sensor
The TX7U outdoor temperature/humidity sensor can be added to your existing
units in operation. The outdoor temperature/humidity sensor measures the
outdoor temperature and humidity (or any other location you wish to know the
temperature and humidity) and transmits the data to the indoor display station.
INVENTORY OF CONTENTS
1.
Outdoor temperature/humidity sensor.
2.
Mounting bracket.
3.
Rain protector.
4.
Two each, ½" Philips mounting screws.
5.
One strip double sided adhesive tape.
6.
Instruction manual and warranty return card.
ADDITIONAL EQUIPMENT (not included)
1.
One Philips screwdriver.
2.
One Flat screwdriver.
3.
Two fresh AA 1.5V batteries.
I. SETTING UP
Before you begin, assign a number to each outdoor temperature/humidity sensor
(i.e. #1 for outdoors, #2 for the basement, etc.) if you have multiple sensors. This
will help you determine which temperature, from which outdoor
temperature/humidity sensor, you are reading on the indoor display station.
Note: Remove batteries from all existing units in operation—including outdoor
temperature/humidity sensor units and indoor display stations. When setting up
multiple units it is important to insert batteries first into all the outdoor
temperature/humidity sensors, and in numeric sequence. Second install batteries
into the indoor display station. Transmission problems will arise if this is not done
correctly and if the total time for setup exceeds 6 minutes.
A.
BATTERY INSTALLATION
Follow these directions when first setting up, when replacing batteries,
or for resetting purposes.
1.
Remove the batteries from all existing display units in operation.
2.
Using a screwdriver, unscrew and open the battery cover located
at the front of the outdoor temperature/humidity sensor.
Battery
compartment
Outdoor
temperature/humidity
sensor
Mounting Bracket
Battery cover
Advertisement
Related Manuals for La Crosse Technology Outdoor Temperature/Humidity Sensor TX7U
Summary of Contents for La Crosse Technology Outdoor Temperature/Humidity Sensor TX7U
- Page 1 TX7U Outdoor Temperature/Humidity Sensor The TX7U outdoor temperature/humidity sensor can be added to your existing units in operation. The outdoor temperature/humidity sensor measures the outdoor temperature and humidity (or any other location you wish to know the temperature and humidity) and transmits the data to the indoor display station. Outdoor temperature/humidity sensor...
- Page 2 Note: Outdoor temperature/humidity sensors will not usually read the same temperature. This is due to variants such as drafts and handling. This is normal. Observe the correct polarity and install 2 AA alkaline batteries in each unit in sequential order. The batteries will fit tightly—make sure they do not spring free.
-
Page 3: Maintenance And Care
Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. Opening the casings invalidates the warranty. Do not try to repair the unit. Contact La Crosse Technology for repairs. IV. SPECIFICATIONS Temperature measuring... - Page 4 La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above.
-
Page 5: Fcc Disclaimer
LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY.