Connecting An External Device (I.link Connection); Recording The Camera Picture On An External Device - Sony PMW-500 Operation Manual

Store the clips to be edited on the HDD of your
computer in advance, using the supplied
application software.
Some editing software may not operate properly.
Be sure to confirm before use that it conforms to
the recording formats used with this camcorder.
148

Connecting an External Device (i.LINK Connection)

Connecting an External
Device (i.LINK
Connection)
FAT
You can record the same images as those
recorded on the memory card in this camcorder
on an external device connected to the i.LINK
(HDV/DV) connector, or record the playback
picture of the external device on the memory card
in the camcorder.
When you connect the camcorder to a non-linear
editing system that supports HDV format, you
can edit the images recorded on the memory card
in the camcorder.
Notes
• i.LINK connection is available only in FAT mode.
• Use the i.LINK (HDV/DV) connector only for one-to-
one i.LINK connection.
• When you change a setting which affects output
signals from the i.LINK (HDV/DV) connector, such as
HD/SD, HD System Line, System Frequency, and Rec
Format under OPERATION >Format in the setup
menu or i.LINK I/O and Down Converter under
OPERATION >Input/Output in the setup menu,
disconnect the i.LINK cable and change the setting.
Changing such a setting with the i.LINK cable
connected may cause improper operation of the
connected i.LINK device.
• The external signal input via the i.LINK connection
that can be recorded on the camcorder is HDV streams
only. You cannot record DV streams via the i.LINK
connection.
Recording the Camera Picture on
an External Device
The picture being shot with this camcorder is
output as an HDV or DV stream via the i.LINK
(HDV/DV) connector. It can be recorded on a
connected HDV or DVCAM recorder in
synchronization with a recording start/stop
operation on this camcorder.
1
Perform the preparatory settings of the
camcorder.