KVH Industries TracVision C3 Owner's Manual page 26

A Guide to TracVision C3
Baseplate Connectors Facing
Front of Vessel – Recommended
Drain Hole Locations
You MUST drill out the drain holes
as indicated to ensure that any
moisture that enters the baseplate
is able to drain. Ensure that
factory-drilled holes are completely
sealed.
2-8
16a. (Alternate Drain Hole Locations) If the antenna
Figure 2-11
Drain Hole Positions
17. Place the radome onto the baseplate (labels facing
18. Drill the cable access hole (marked in
unit is installed with the baseplate connectors
facing the bow of the vessel, drill out
(5 mm)-drain holes in the rear-facing side of the
baseplate as illustrated in Figure 2-11. The
existing factory-drilled drain holes shown in
Figure 2-10 must then be plugged with silicone
rubber sealant.
Recommended
3/16" (5 mm)
Drain Hole Angle
(relative to baseplate)
the sides of the vessel) and secure in place using
the 8 pan head screws and flat washers removed
in Step 3.
3
⁄ "
1 6
Angle of Hole, relative to front
Bow
Angle of Hole, relative to front
Step 5).