KTM 50 SX PRO JUNIOR LC Owner's Manual [Page 26]: Checking Coolant Level
Ktm motor cycle owner's manual.
10 mm
when engine is cold
1
2
6
3
4
Checking coolant level
The coolant should be 10 mm (0.4 in) above the radiator fins when the
engine is cold (see illustr.). In the event of the coolant being drained, always
fill and bleed the system.
I
F POSSIBLE
HAVE TO OPEN THE RADIATOR CAP WHEN THE ENGINE IS HOT
CAP AND OPEN SLOWLY TO RELEASE PRESSURE
Cleaning the air filter *
The air filter must be cleaned at intervals depending on the amount of dust
accumulated. To clean the air filter, first remove the seat. Then press both
retaining clips
1
consists of a foam rubber insert soaked with filter oil.
– D
O NOT CLEAN THE FOAM FILTER WITH FUEL OR PETROLEUM SINCE THESE WILL
DAMAGE THE FOAM
AIR FILTER MAINTENANCE
– N
EVER OPERATE YOUR MOTORCYCLE WITHOUT AN AIR FILTER
AND DIRT MAY GET INTO THE ENGINE AND LEAD TO INCREASED WEAR
– T
HE HOLDER MUST RETAIN THE AIR FILTER THROUGHOUT ITS ENTIRE CIRCUMFERENCE
I
F THE FILTER HAS BEEN MOUNTED INCORRECTLY
,
AIR
THEREBY CAUSING INCREASED ENGINE WEAR
Thoroughly wash the foam filter in special cleaning fluid and allow it to dry
well. Only press out the filter, do not wring it out under any circumstances.
Oil the dry foam filter with a high-grade filter oil. Also clean the air filter
box. Check carburetor collar for damage and that it is filled correctly.
Insert the air filter in the opening and fasten it with the filter holder. Then
mount the seat.
Exhaust system *
5
The silencer is filled with glass-fiber yarn for damping. When in use, the
glass-fiber yarn becomes loose or coked with oil carbon. This can lead to a
power loss and a reduction of the silencer damping. The glass-fiber yarn
packing can be replaced in a few easy steps.
To replace, remove the silencer from the vehicle and mark the position of
the outer tube
6
. Pull of the outer tube and remove the old glass-fiber yarn packing
from the inner tube. Thoroughly clean all parts.
7
To assemble, mount a new glass-fiber yarn packing onto the inner tube (see
illustration) and slide into the outer tube. Mount end cap and fix with
screws
match the positions you marked. Mount the silencer and check the exhaust
system for tightness.
NOTE: Glass fiber yarn packages are offered by your licensed KTM dealer.
T
HE EXHAUST SYSTEM BECOMES VERY HOT WHILE THE MOTORCYCLE IS RUNNING
AVOID BURNS DO NOT START WORK ON THE EXHAUST SYSTEM UNTIL IT HAS PROPERLY
COOLED DOWN
WARNING
,
ALWAYS CHECK LEVEL OF COOLING LIQUID WHEN ENGINE IS COLD
1
, remove the filter holder and the air filter
!
CAUTION
. KTM
RECOMMENDS THE PRODUCTS MADE BY
.
3
4
to the inner tube
5
. Before tightening the screws, turn the outer tube until they
WARNING
.
,
USE A RAG TO COVER THE
.
2
. The air filter
!
T
WIN
. O
THERWISE
.
,
THE ENGINE WILL TAKE IN UNFILTERED
.
5
. Remove screws
and the end cap
. I
F YOU
A
IR FOR
,
DUST
.
25
7
.
TO
Comments to this Manuals
Latest comments: