Theater-Throughput Setup - Krell Industries KRC-HR Owner's Reference Manual

THEATER-THROUGHPUT SETUP
NOTE: If the KRC-HR must be handled after the top cover has been removed,
the unit must be held only on the sides of the chassis. Never move the KRC-HR
while the top cover is off by holding the front panel.
When reinstalling the top cover, insert the four screws into the chassis sides
first and lightly tighten them. Install the screws in the top surface and tighten
them lightly. Then tighten all screws firmly, starting with the side screws and
finishing with the top screws.
SETTING THE $4 INPUT FOR THROUGHPUT FUNCTIONS
This procedure should be done with the unit OFF.
a. Remove the KRC-HR top cover screws with the T-15 Torx wrench
supplied.
b. Locate the switch towards the front of the board that is labeled S4/Proc.
Set the dip switch to the proc (processor) position.
NOTE: The default position of this switch sets the $4 input for standard
operation. In this position, $4 is identical to the S1, $2 and $3 inputs.
c. Place the top cover back on the KRC-HR and insert the cover screws.
©
© ~
Proc.
¯ ¯
¯ ¯
¯
¯
¯ ¯
¯ ¯
¯ ¯
¯ ¯
¯ ¯
¯ ¯
¯ ¯
4