Korg TRITON Extreme TRITON Extreme music workstation/sampler Operation Manual page 126

5 Navigate to the directory that contains the file you
want to load, and select the .SNG file.
Press the Open button to move to a lower level, or
press the Up button to move to a higher level.
The selected .SNG file will be highlighted.
6 Press the page menu button to access the page menu,
and choose "Load Selected."
A dialog box will appear.
The contents and settings of the dialog box will differ
depending on the type of file that you are loading.
7 Check the "Load ********.PCG too" check box.
When you execute loading, the .PCG file will be loaded
along with the .SNG file.
Check the "Load ********.KSC too" check box.
When you execute loading, the .KSC file will be loaded
along with the .SNG file.
Use ".PCG Contents" to specify the data that you
want to load.
If you want to load all the data in the .PCG file, select
All.
Use "Select .SNG Allocation" to specify the destina-
tion to which the song data will be loaded.
"Append" will load the song into the song number
that follows the song(s) currently existing in internal
memory, without leaving a vacant number.
"Clear" will erase all songs and the cue list from inter-
nal memory, and load the songs into the numbers from
which they were saved.
Use "Select .KSC Allocation" to specify where the
multisamples and samples will be loaded.
"Append" will load the data into the next available
vacant numbers following the multisamples and sam-
ples that are already in sample memory (RAM).
"Clear" will erase all multisamples and samples from
sample memory (RAM), and load the data in the same
configuration with which it was saved.
8 Press the OK button to execute loading.
Never remove the media while data is being loaded.
122
Loading individual banks from a .PCG file
1 Select the .PCG file containing the data you want to
load, and choose the page menu command "Load
Selected."
Refer to steps 1–4 of "Loading .PCG, .SNG, and .KSC
files," select the .PCG file in step 5.
2 Press the page menu button to open the page menu,
and choose "Load Selected."
You can load individual banks by using ".PCG Con-
tents" in the dialog box to select the load-source bank,
and "To" to select the load-destination bank.
When you execute loading, only the programs, combi-
nations, drum kits, and user arpeggio pattern data of
the selected bank will be loaded into the load-destina-
tion bank you specify. Global setting data will not be
loaded.
If you set ".PCG Contents" to Bank A, and "To" to
Bank A, data will be loaded as follows.
Programs
• Bank A: loaded into bank A
Combinations
• Bank A: loaded into bank A
Drum Kits
• 000–015 (A/B): loaded into bank A/B
Arpeggio Patterns
• 000–199 (A/B): loaded into bank A/B
When data is loaded into a bank that is different than its
original bank, the data (bank, program, pattern, and kit
numbers, etc.) will automatically be reconfigured so that
after loading, the various types of data will correspond
correctly in each mode.
The following data will also be reconfigured automati-
cally if you have checked "Load .SNG too" (so that song
data is loaded at the same time), the following data will
also be reconfigured automatically in order to ensure that
the song data plays back correctly.
• The bank of each program used by combinations
• The pattern number of each user arpeggio pattern
used by the combinations/programs/songs
• The kit number of the drum kit used by each program
• The bank of the program used by each track of the
song
• If the song contains track/pattern events, the program
banks within these events