Rear Panel - Korg TONEWORKS AX10G Owner's Manual

FUNCTION button
12
To edit one of the parameters printed on the front
panel in blue, hold down this button and operate the
corresponding knob or button. For example, you can
edit the speed of the modulation effect by holding
down this button and using the MODULATION
DEPTH buttons.
13
MASTER (CANCEL) buttons
These buttons adjust the overall volume of the
AX10G (MASTER).
When the AX10G is ready to write (store), pressing
either of these buttons will cancel the Write operation
(CANCEL).
14 WRITE button
Use this button to write (store) a program.
When you press this button, the AX10G will enter
"write-ready" mode; if you press this button again,
the program will be written (stored). (p.12)
15
PEDAL FX/BANK HOLD button
This button selects the effect that will be controlled
by the expression pedal (Pedal Effect).
Each time you press the button, the LED will change
color to indicate the pedal effect that will be con-
trolled.
ORG:WAH (orange): Pedal wah
RED:MOD (red): The effect selected by MODULATION
GRN:AMB (green): The effect selected by AMBIENCE
OFF:VOLUME (dark): Volume pedal

Rear panel

20
INPUT L/H select switch
Set this switch according to the pickup output of your
guitar.
H: Suitable for a pickup with high output, such as a
humbucking pickup
L: Suitable for a pickup with low output, such as a
single coil pickup
21
INPUT jack
Connect your guitar to this jack. Use a 1/4" mono
plug. If the AX10G is running on batteries, the power
will come on when you plug into this jack.
If the AX10G is running on batteries, the power will
not come on if a 1/4" stereo plug is inserted.
25 24 20 21
If something other than WAH is selected for the pre-
effect, you cannot use the PEDAL FX button to
select WAH.
By holding down the FUNCTION button and pressing
this button, you can select "bank hold" mode as the
way in which programs will be selected (BANK
HOLD). Refer to "Selecting programs: b" (p.9).
16 Expression pedal
You can use this expression pedal to control effects
or volume. By advancing the pedal all the way
forward you can switch the selected pedal effect on/
off.
17 PEDAL LED
This LED will light if the expression pedal is active.
18 ORIGINAL VALUE LED
This LED will light if the edited value is identical to
the saved (original) value.
19
Program select switches DOWN/BANK DOWN, UP/
BANK UP –BYPASS, TUNE–
Use these switches to select programs. You can
select programs in one of three ways. Refer to
"Selecting programs" (p.9).
If you press the UP and DOWN switches simulta-
neously, the effects will be bypassed and the tuner
will operate (BYPASS) (p.9).
22 OUTPUT jack
Connect this jack to your guitar amp, recorder, or
headphones.
23
AMP/LINE select switch
Set this to "AMP" if you are plugging into an amp, or
to "LINE" if you are plugging into a recorder or using
headphones.
24 DC9V
The separately sold AC adapter can be connected
here (p.8). When this is connected, the power will be
turned on automatically.
You must only use the specified AC adaptor (p.14).
25
Cable hook
If the separately sold AC adapter is used, connect the
cable of the AC adapter around this hook (p.8).
22 23
7