Removing The Driver Software - Windows - Konica Minolta DiMAGE X60 Instruction Manual

The add new hardware wizard will confirm the location of
the driver. The letter designating the CD-ROM drive will
vary between computers. Click "Next" to install the driver
in the system.
One of three drivers may be located: MNLVENUM.inf,
USBPDR.inf, or USBSTRG.inf.
The last window confirms the driver has been installed.
Click "Finish" to close the add new hardware wizard.
Restart the computer.
When the my-computer window is opened, a new remov-
able-disk icon is displayed. Double click on the icon to
access the camera's memory card or internal memory; see
page 86.
84 Data-transfer mode

REMOVING THE DRIVER SOFTWARE - WINDOWS

1. Connect the camera to the computer with the USB cable. Other devices must not be connected
to the computer during this procedure.
2. Right click on the My-computer icon. Select "properties" from the drop-down menu.
Windows XP: from the start menu go to the control panel. Click on the performance and mainte-
nance category. Click "System" to open the system properties window.
3. Windows XP and 2000 Professional: select the hardware tab in the properties window and click
the device-manager button.
Windows Me and 98: click the device-manager tab in the properties window.
4. The driver file will be located in the universal-serial-bus-controller or other-devices location of the
device manager. Click on the locations to display the files. The driver should be indicated with
Konica Minolta, the camera name, or "USB Mass Storage Device." Under certain conditions, the
driver name may be different. However, the driver will be indicated by either a question mark or
exclamation point.
5. Click on the driver to select it.
6. Windows XP and 2000 Professional: click on the action button to display the drop-down menu.
Select "uninstall." A confirmation screen will appear. Clicking "Yes" will remove the driver from the
system.
Windows Me and 98: click the remove button. A confirmation screen will appear. Clicking "Yes"
will remove the driver from the system.
7. Disconnect the USB cable and turn off the camera. Restart the computer.
85