. Technical Data Mains voltage: AC/alternating current: 220 V ~ 50 Hz DC/direct current : 12 V 1.5 V x 8 type C/LR14/UM2 Output: 2 x 1.2 watt (RMS) 30 watt (PMPO) Radio Reception range VHF/FM 88 MHz to 108 MHz Reception range Medium-wave/AM 540 kHz to 1610 kHz...
We do not accept any liability/warranty for damage in- curred as a result of incorrect use! Manual_KH2242_EN . Function With the portable eBench KH 2242 CD Player/Radio you can … • Playback audio CDs • Receive VHF and medium-wave radio stations 16.09.2003, 15:04 Uhr...
. Controls and displays .. General 18. Volume control 5. Function selector .. CD 1. CD compartment 9. Play/Pause button 13. Stop button 12. Back button 8. Next button 10. Repeat button 11. Mix button .. Radio 4. Frequency-range selector 17.
. Point of installation and safety instructions Set up your new portable eBench KH 2242 CD Player/Radio on a level, smooth non-slip base. To prevent damage, functional interference and the danger of an electric shock do not use the set …...
• Exposure to moisture • Water entering the set • Overheating . Getting started .. Connecting to the power supply The eBench KH 2242 portable CD Player/Radio can be op- erated • with batteries • with the supplied mains cable plugged into a power socket.
Please note! Only use the supplied mains cable to connect the set to the mains! The use of mains cables that were not intended for the eBench KH 2242 portable CD Player/Radio can result in irreparable damage to the set! Warning!
Turn the tuning control at the back of the set to tune in a radio station with good reception characteristics. The currently tuned frequency is indicated on the frequency range scale on the front of the set. Set the desired volume by turning the volume control on the back of the set.
CD will then be played. The display will indicate … • The track number of the music title that is currently be- ing played, for instance “1” for the first track on the CD, • “PLAY” to the left of the current track number. ...
Continue pressing the “Next”/”Back” button until the display indicates the number of the desired track. Playback of the selected track commences instantly with- out having to press the “Play/Pause” button. c) … With stopped CD playback (PAUSE mode): ...
... Repeat CD To repeat all tracks on the audio CD press the “Repeat” but- ton twice during playback of a music title. Activation of CD repeat is indicated by “RPT” appearing on the LCD display to the left of the current track number. The entire audio CD continues to be repeated until CD re- peat is turned off.
Page 15
. Cleaning Only use a slightly moist cloth to clean the case surface of the set. Ensure when cleaning that no moisture enters the set. The inside of the CD compartment must only be cleaned with a clean, dry brush (e.g. lens brush available from pho- tographic dealers).
Page 16
Consult our service partner in your vicinity in the event of the following … • If the functional faults described in Chapter 12 cannot be remedied in the described manner. • If functional faults occur which are not described in Chap- ter 12.