Connecting To A Wireless Network; Before You Connect; Connecting To A Wireless Network Using The Wifi Setup Wizard - Kodak ESP 7200 Series User Manual

Connecting to a wireless network

Before you connect

Connecting to a wireless network using the WiFi Setup Wizard

Connecting to a listed network
To connect your printer to an 802.11 wireless (Wi-Fi) network, refer to the following
information.
You need:
• A computer equipped with a network interface card or wireless networking
support.
• A working 802.11 wireless network. Kodak recommends that you use a wireless
access point/router that uses Dynamic Host Configuration Protocol (DHCP).
• Your network name (SSID - Service Set Identifier). You can obtain your SSID
from the wireless access point, most commonly a router, using the router's
embedded Web server. See the manufacturer's documentation provided with
your wireless system for more information.
• Your Wired Equivalent Privacy (WEP) key or Wi-Fi Protected Access
(WPA/WPA2) passphrase.
• To be sure to temporarily disable your firewall until the printer is successfully
installed and communicating.
You can use the WiFi Setup Wizard on the printer to connect to your wireless
network. Read the following procedures and use the one that is appropriate for your
network setup.
See Before you connect
network.
To connect to a listed network using the WiFi Setup Wizard:
1. Press Home .
2. Press to select Network Settings , then press OK .
3. With WiFi Setup Wizard selected, press OK .
NOTE: The Wi-Fi radio is turned on automatically when you select WiFi Setup
Wizard.
www.kodak.com/go/aiosupport
KODAK ESP 7200 Series All-in-One Printer
to determine what is needed to connect your printer to the
5