Page 5
Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
Page 6
English while operating power tools may result in serious GENERAL POWER TOOL SAFETY WARNINGS personal injury. Use personal protective equipment. Always wear eye WARNING protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection Read all safety warnings and all instructions.
Page 7
English maintained cutting tools with sharp cutting edges are in the system. less likely to bind and are easier to control. Protect material lines and air lines from damage or Use the power tool, accessories and tool bits etc. in puncture.
Page 8
NOTE: The tool is not designed for commercial application. Always wear eye protection with side shields marked to This product will accept Ryobi One+ 18 V lithium-ion comply with ANSI Z87.1. Failure to do so could result battery packs and Ryobi One+ 18 V nickel-cadmium in objects being thrown into your eyes resulting in battery packs.
Page 9
English BATTERY PROTECTION FEATURES DIGITAL GAUGE Ryobi lithium-ion batteries are designed with features that See figure 3 protect the lithium-ion cells and maximize battery life. The digital gauge is multifunctional serving as a pressure If the product stops during use, the battery needs to be gauge, monitoring the amount of pressure being applied recharged.
Page 10
English Turn the hose clockwise as far as it will turn. INFLATING WITH THE HIGH PRESSURE HOSE AND ACCESSORIES Press the low pressure (I) switch to start inflating. See figures 7 - 9 When the desired pressure is reached, turn the switch off.
Page 11
English Clamp the end of the air chuck down onto the presta ENVIRONMENTAL PROTECTION valve adaptor by pressing air chuck clamp down until it locks into place. Recycle raw materials instead of disposing After inflation, remove air chuck and tighten locking of as waste.
Page 12
Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand...