Alarm Removal - Kidde KN-COB-IC Manual

Battery Replacement (If Equipped)

Alarm Removal

If tamper resist feature has been activated, refer to tamper
resist feature description on page 10 for removal
instructions.
Remove the alarm from the mounting plate by rotating the
alarm in the direction of the "OFF" arrow on the cover. To
disconnect the AC Quick-Connector harness, squeeze the
locking arms on the sides while pulling the connector
away from the bottom of the alarm (see Figure 2).
FOR ALARMS EQUIPPED WITH 9 VOLT BATTERY
BACKUP
After the alarm has been removed, you can open the
battery door and replace the battery. Battery installation
instructions are provided on the inside of the battery door.
When installing the battery, orient the battery as shown on
unit label. Press the battery reminder tab down into the
battery compartment and install the battery (see Figure 4).
FIGURE 4 BATTERY REPLACEMENT
Battery
tab
CAUTION! If the battery reminder tab is not held down in
the battery compartment by the battery, the battery door will
not close, the AC Quick-Connector will not attach to the
alarm, and the alarm will not attach to the mounting plate.
After installing or changing the battery, reinstall your alarm.
Test your alarm by using the Test/Reset button and check
that the green "Power" LED is on.
1 6