Behringer Blues Overdrive BO300 Quick Manual

BLUES OVERDRIVE BO300
Classic Overdrive Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER BLUES OVERDRIVE BO300.
This classic effects pedal is specifically designed to deliver the warm and emotive distortion usually known
from 30-year-old classic tube amps. Thanks to its high-performance features you will achieve the tone of a
vintage and bluesy tube amp that captures every nuance of your playing. And if you feel like it, you can rock
out with full-blast distortion.
1. Controls
(1)
(2)
(7)
(1) The LEVEL control adjusts the output level.
(2) The TONE control adds tube-like warmth to the overall sound.
(3) Use the GAIN control to adjust the amount of overdrive.
(4) The ON/BATT LED illuminates when the effect is activated. It also serves as a battery
level indicator.
(5) Use the footswitch to activate/deactivate the effect.
(6) Use this 1/4" TS IN connector to plug in the instrument cable.
(7) The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery
(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to
scratch the unit.
◊
The BO300 has no on/off switch. As soon as you insert the jack into the in connector,
the BO300 begins running. When not using the BO300, remove the jack from the in
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
(4)
(3)
(6)
(5)