Download Print this page

Advertisement

MO0602-EA
Getting Acquainted
Congratulations upon your selection of this CASIO watch. To get the most out of your
purchase, be sure to read this manual carefully.
Keep the watch exposed to bright light
Bright Light
Solar cell
• The watch continues to operate, even when it is not exposed to light. Leaving the
watch in the dark can cause the battery to run down, which will result in some watch
functions to be disabled. If the battery goes dead, you will have to re-configure watch
settings after recharging. To ensure normal watch operation, be sure to keep it
exposed to light as much as possible.
Battery charges in the light.
Bright Light
Solar cell
(Converts light to
electrical power.)
LEVEL 1
LEVEL 2
LEVEL 3
Charge
LEVEL 4
Rechargeable battery
General Guide
• Press C to change from mode to mode.
• In any mode (except when a setting screen is on the display), press B to illuminate
the display.
Radio-controlled Timekeeping
PM
indicator
Day of week
Hour : Minutes
Seconds
• The first thing you should do after purchasing this watch is to set your Home City,
which is the city where you will use the watch normally. For more information, see
"To set your Home City" below.
• When using the watch outside the range of the time signal transmitter, you have to
adjust the current time setting manually as required. See "Timekeeping" for more
information about manual time settings.
To set your Home City
City code
l
City
City
Other major cities in same time zone
Code
LIS
Lisbon
Dublin, Casablanca, Dakar, Abidjan
LON
London
BCN
Barcelona
MAD
Madrid
PAR
Paris
Amsterdam, Algiers, Hamburg,
MIL
Milan
Frankfurt, Vienna
ROM
Rome
BER
Berlin
STO
Stockholm
Helsinki, Istanbul, Beirut, Damascus,
ATH
Athens
Cape Town
3. Press A to exit the setting screen.
Operation Guide 3017
The electricity generated by the solar cell of the watch is
stored by a built-in battery. Leaving or using the watch where
it is not exposed to light causes the battery to run down.
Make sure the watch is exposed to light as much as possible.
• When you are not wearing the watch on your wrist,
position the face so it is pointed at a source of bright light.
• You should try to keep the watch outside of your sleeve
as much as possible. Charging is reduced significantly if
the face is only partially covered.
Battery discharges in the dark.
Electrical
energy
All
LEVEL 1
functions
LEVEL 2
enabled
LEVEL 3
Dis-
charge
LEVEL 4
Timekeeping Mode
Press C.
This watch receives a time calibration signal and updates
its time setting accordingly. The time calibration signal
includes both Standard Time and Daylight Saving Time
(summer time) data.
• This watch is designed to pick up the time calibration
signal transmitted from Mainflingen, Germany and the
signal from Rugby, England.
• In the Timekeeping Mode, you can press A to toggle
the display contents.
Current Time Setting
This watch adjusts its time setting automatically in
accordance with a time calibration signal. You can also
perform a manual procedure to set the time and date,
when necessary.
1. In the Timekeeping Mode, hold down A until the city
code starts to flash, which indicates the setting screen.
2. Use D(east) and B(west) to select the city code you
want to use as your Home City.
• The following are the city codes for major cities in the
Western Europe time zones.
• The actual level at which some functions are disabled depends on the watch model.
• Frequent display illumination can run down the battery quickly and require charging.
The following guidelines give an idea of the charging time required to recover from a
single illumination operation.
Approximately 5 minutes exposure to bright sunlight coming in through a window
Approximately 50 minutes exposure to indoor fluorescent lighting
• Be sure to read "Power Supply" for important information you need to know
when exposing the watch to bright light.
If the display of the watch is blank...
If the display of the watch is blank, it means that the watch's Power Saving function
has turned off the display to conserve power.
• See "Power Saving Function" for more information.
About This Manual
Some or all
functions
disabled
World Time Mode
Stopwatch Mode
Important!
• Normally, your watch should show the correct time as soon as you select your Home
City code. If it does not, it should adjust automatically after the next auto receive
operation (in the middle of the night). You can also perform manual receive or you
can set the time manually.
• If you are in an area that does not use Daylight Saving Time (summer time), turn off
the DST setting.
Time Calibration Signal Reception
There are two different methods you can use to receive the time calibration signal:
auto receive and manual receive.
• Auto Receive
With auto receive, the watch receives the time calibration signal automatically up to
six times a day. When any auto receive is successful, the remaining auto receive
operations are not performed. For more information, see "About Auto Receive".
• Manual Receive
Manual receive lets you start a time calibration receive operation with the press of a
button. For more information, see "To perform manual receive".
Important!
• When getting ready to receive the time calibration signal, position the watch as
shown in the nearby illustration, with its 12 o'clock side facing towards a window.
Make sure there are no metal objects nearby.
Resin Band
• The watch should not be on its side or facing the wrong way.
• Proper signal reception can be difficult or even impossible under the conditions listed
below.
Inside or
Inside a
among
vehicle
buildings
• Depending on the model of your watch, display text
appears either as dark figures on a light background, or
light figures on a dark background. All sample displays
in this manual are shown using dark figures on a light
background.
• Button operations are indicated using the letters shown
in the illustration.
• Each section of this manual provides you with the
information you need to perform operations in each
mode. Further details and technical information can be
found in the "Reference" section.
Alarm Mode
Countdown Timer Mode
Metal Band
Near
Near a
Near high-
household
construction
tension
appliances or
site, airport, or
power lines
office
other sources
equipment,
of electrical
or a mobile
noise
phone
Among or
behind
mountains
1

Advertisement

loading

Summary of Contents for Casio 3017

  • Page 1 Operation Guide 3017 Getting Acquainted Congratulations upon your selection of this CASIO watch. To get the most out of your • The actual level at which some functions are disabled depends on the watch model. purchase, be sure to read this manual carefully.
  • Page 2: World Time

    Operation Guide 3017 • Signal reception is normally better at night than during the day. To perform manual receive • Time calibration signal reception takes from two to six minutes, but some cases it 1. Place the watch on a stable surface so its top (12 can take as long as 12 minutes.
  • Page 3: Countdown Timer

    Operation Guide 3017 Countdown Timer You can set the countdown timer within a range of one to To toggle a city code time between Standard Time and Daylight Saving Time 60 minutes. An alarm sounds when the countdown 1. In the World Time Mode, use D to display the city code reaches zero.
  • Page 4: Power Supply

    • When setting the time, you can also configure settings for the illumination duration, or CASIO distributor about having it replaced. the 12/24-hour format, and power saving on/off, and you can specify the screens •...
  • Page 5 Operation Guide 3017 * If you leave the calendar screen displayed for two or three minutes without Setting the Time and Date performing any operation, the watch will automatically return to the timekeeping Make sure you select your Home City code before you change the current time and screen.
  • Page 6: City Code Table

    Operation Guide 3017 City Code Table • The watch is designed to update the date and day of the week automatically for the City City Other major cities in same time zone Code Differential period January 1, 2000 to December 31, 2099. Setting of the date by a time Pago Pago –11.0...

This manual is also suitable for:

3016