Unit Dimensions - Front; Unit Minimum Clearances - York DNZ 024 Installation Manual

66433-YIM-B-1004
GAS SUPPLY 1-1/4" DIA.
HOLE (1/2" NPTI
CONNECTION)
UNIT CONDENSATE
CONNECTION 3/4" NPTI
(TRAP RECOMMENDED)
HIGH VOLTAGE
CONN. 1-3/8" DIA.
KNOCKOUT
HIGH VOLTAGE
CONN. 7/8" DIA.
KNOCKOUT
GAS SUPPLY 1-1/4" DIA.
KNOCKOUT (1/2" NPTI
CONNECTION)
LOW VOLTAGE CONN.
1-3/8" DIA. KNOCKOUT
X 7/8" HOLE
FIGURE 6 - UNIT DIMENSIONS - FRONT
TABLE 9: UNIT DIMENSIONS FRONT
UNIT SIZE
024, 030, 036
042, 048, 060
Unitary Products Group
VENT AIR OUTLET HOOD
BLOWER SERVICE
ACCESS COMPARTMENT
PANEL
B
3-3/4
2-1/2
47-1/4
(OVERALL)
DIMENSION
"A" "B"
33-1/2 18-1/4
41-1/2 23-1/8
5-3/8
1-1/2
11
12-3/4
3-1/3
2-5/8
TABLE 10: UNIT MINIMUM CLEARANCES
FRONT
BACK
LEFT SIDE (Filter-Access)
RIGHT SIDE
BELOW UNIT
ABOVE UNIT
1.
A 1" clearance must be provided between any combus-
tible material and the supply air ductwork.
2.
The products of combustion must not be allowed to
accumulate within a confined space and recirculate.
3.
Units may be installed on combustible floors made from
wood or class A, B, or C roof covering material.
4.
Units must be installed outdoors. Overhanging struc-
tures or shrubs should not obstruct condenser air dis-
charge outlet.
CONDENSER COIL
A
2-3/8
REFRIGERANT
CONNECTIONS
COMBUSTION AIR
INLET LOUVERS
FRONT
GAS/ELECTRIC CONTROL
49-1/8
SERVICE ACCESS
COMPARTMENT PANEL
(OVERALL)
All dimensions are in inches.
They are subject to change with-
out notice. Certified dimensions
will be provided upon request.
CLEARANCES
36"
0"
24"
12"
3
0"
4
36" (For Condenser Air Discharge
1 2
13