Kenwood KAC-PS520 Instruction Manual page 11

Kenwood power amplifier instruction manual kac-x520 kac-ps520
Hide thumbs Also See for KAC-PS520:
Table of Contents

Advertisement

Available languages

Available languages

■ Tri-mode
CENTER UNIT
INFRASONIC
1
2
ON
OFF
REMOTE
●Principle of Tri-mode
Method of frequency band division using a coil and capacitor...in case of 6dB/oct. slope
Crossover Frequency
0 dB
-3 dB
L
Example:
When it is required to set a crossover frequency of 120 Hz using speakers with an
impedance of 4 ohms.
Prepare commercially-available coil and capacitor with the closest ratings to the results
calculated from the formula above. The capacitor rating should be as close as possible to 331.25
(µF) and the coil rating should be as close as possible to 5.3 (mH).
2CAUTION
• If you wish to bridge-connect a speaker, the speaker impedance must be no less than 4 ohms.
Connecting a speaker with an impedance lower than 4 ohms may damage the unit.
• Be sure to connect capacitors to speakers to which high frequencies will be passed. Failure to
do so will result in a drop of the combined impedance with the subwoofer.
• Ensure that the withstand voltage and current ratings of the capacitors (C) and coils (L) are
sufficient.
C
L
L
R
R
C
B.M.S.
FILTER
3
OFF
OFF
+12dB
HPF
Coil (L): Passes low frequencies and blocks high
Capacitor (C): Passes high frequencies and blocks low
C
C=
Frequency
L=
L
(High pass)
OPERATION
4
MONO(L ch)
STEREO
LPF
frequencies. (Low pass)
frequencies. (High pass)
159000
(µF)
fc x R
fc=Cut of Frequency (Hz)
159 x R
R=Speaker Impedance (Ω)
(mH)
fc
Subwoofer
(L + R) (Bridged)
English
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ps520Kac-x520

Table of Contents