Operating Features - Kenwood TK-860G Service Manual Supplement

Emergency
Pressing this key for longer than 1 second causes the
transceiver to enter the emergency mode. The transceiver
jumps to the programmed "Emergency the group and chan-
nel" and transmits for 25 seconds.
The transceiver disables mic mute while transmitting.
After finishing transmission, the transceiver receivers for 5
seconds. The transceiver mutes the speaker while receiv-
ing. Following the above sequence, the transceiver contin-
ues to transmit and receive.
Emergency mode system chart (TK-860G)
Foot switch 1 push
After 1 min.
Horn/Light operation
[D/A] key 1 push
Horn/Light operation stop
Emergency mode system chart (TK-862G)
Foot switch 1 push
After 1 min.
Horn/Light operation
[D/A] key 1 push
Horn/Light operation stop

OPERATING FEATURES

Foot switch 1 push
Emergency mode
Emergency channel
TX 25 sec. RX 5 sec.
or
*2
Emergency ACK code receive
Emergency reset code receive
Emergency mode reset
Normal operation
Foot switch 1 push
Emergency mode
Emergency channel
TX 25 sec. RX 5 sec.
or
*2
Emergency ACK code receive
Emergency reset code receive
Emergency mode reset
Normal operation
TK-860G/862G
Radio Password (TK-860G only)
When the password is set in the transceiver, user can not
use the transceiver unless enter the correct password.
This code can be up to 6 digits from 0 to 9 and input with
the key, and "SCN" key.
(Hold it down for about one second.)
*1
LCD dots light
*3
LCD dots light
or
*2
[MON] key + Foot SW 1 push
*1 : 3 left most dots light.
*2 : Hold the foot switch again for about one second.
*3 : 2 right most dots light.
(Hold it down for about one second.)
*1
LCD dot status change
Dot
*1
LCD dot status change
or
*2
[MON] key + Foot SW 1 push
*1 : When the dot indicator is on, it turns off.
When the dot indicator is off, it turns on.
*2 : Hold the foot switch again for about one second.
Dots
Dots
Dot
3