Normal Scan; Band Scan; Program Scan - Kenwood TM-271 Instruction Manual

NORMAL SCAN

When you are operating the transceiver in VFO Mode,
3 types of scanning are available: Band Scan, Program
Scan, and MHz Scan.
B S
AND CAN
The transceiver scans the entire band of the frequency
you selected. For example, if you are operating and
receiving at 144.525 MHz, it scans all the frequencies
available for the VHF band. (Refer to receiver VFO
frequency range in the specifications {page 72}.) When
the current VFO receive frequency is outside the Program
Scan frequency range {below}, the transceiver scans the
entire frequency range available for the current VFO.
1 Press [VFO] and turn the Tuning control or press Mic
[UP]/[DWN] to select a frequency outside of the
Program Scan frequency range.
8
2 Press [VFO] (1s) to start Band Scan.
• Scan starts from the current frequency.
• The 1 MHz decimal blinks while scanning is in progress.
3 Press any key other than [F] or [

Band Scan.

Note:
◆
The transceiver scans the frequency range that is stored in Menu
No. 7 (P.VFO) {page 61}.
◆
If you select a frequency within the L0/U0 ~ L2/U2 range in step 2,
Program Scan starts.
40
P
ROGRAM
You can limit the scanning frequency range. There are
3 memory channel pairs (L0/U0 ~ L2/U2) available for
specifying the start and end frequencies. Program Scan
monitors the range between the start and end
frequencies that you have stored in these Memory
Channels. Before performing Program Scan, store the
Program Scan frequency range to one of the Memory
Channel pairs (L0/U0 ~ L2/U2).
■
] (Power) to stop
S
CAN
Storing a Program Scan Frequency Range
1 Press [VFO] and turn the Tuning control or press
Mic [UP]/[DWN] to select your desired start
frequency.
2 Press [F].
• A Memory Channel number appears and blinks.
3 Turn the Tuning control or press Mic [UP]/[DWN]
to select a Memory Channel from L0 ~ L2.
4 Press [MR] to store the start frequency in the
Memory Channel.
5 Turn the Tuning control to select your desired end
frequency.
6 Press [F].